Related Experiment Video
Updated: Aug 19, 2025

Comparison of Two Different Synthesis Methods of Single Crystals of Superconducting Uranium Ditelluride
Published on: July 8, 2021
Selective sulfidation-vacuum volatilization processes for tellurium and bismuth recovery from bismuth telluride waste
Jinping Ma1, Tongtang Shi2, Yifu Li1
1National Engineering Research Center of Vacuum Metallurgy, Kunming University of Science and Technology, Kunming, 650093, PR China; Faculty of Metallurgical and Energy Engineering, Kunming University of Science and Technology, Kunming, 650093, PR China.
Abstract:
Bismuth telluride-based alloy materials are currently the best performing thermoelectric materials at near room temperature; however, their production and use generate waste (e.g., cutting waste and failed grains). There is also lack of efficient recycling strategies for the generated waste. In this study, a selective sulfidation-vacuum volatilization method is proposed for recovering bismuth telluride waste. The Gibbs free energies of the sulfidation reaction of bismuth telluride are calculated, the saturated vapor pressure of each substance is analyzed, and the composition of the products is predicted. Based on the differences among the sulfidation and volatile properties of bismuth and tellurium, by adding sulfur to bismuth telluride waste, the composition of the substances was regulated, and efficient separation of tellurium and bismuth was achieved. We combined theoretical calculations and experimental studies to investigate the effect of process conditions on the separation and recovery of tellurium and bismuth. The results show that bismuth was thoroughly sulfereted and tellurium was a pure metal when the mass ratio of sulfur to bismuth telluride was 0.168, the sulfidation temperature was 573 K, and the holding time was 60 min. After sulfidation of the bismuth telluride waste, the sulfides were telluride and bismuthous sulfide. The sulfides, that resulted from sulfureted bismuth telluride production, were treated via vacuum volatilization. The optimal vacuum volatilization condition was 873 K for 120 min. The purities of tellurium and bismuth sulfide obtained by the selective sulfidation-vacuum volatilization experiment were >99%. The distribution ratios of tellurium and bismuth were 98.46% and 99.59%, respectively. The method thoroughly separated tellurium and bismuth from bismuth telluride waste, considerably reducing the environmental and economic costs compared with those of the conventional processes.
More Related Videos
08:01Sulfate Separation by Selective Crystallization with a Bis-iminoguanidinium Ligand
Published on: September 8, 2016
04:09Demonstrating the Simplicity and In Situ Temperature Monitoring of the Mechanochemical Synthesis of Metal Chalcogenides Suitable for Thermoelectrics
Published on: August 30, 2024
Related Concept Videos
Voltammetry: Stripping Methods
Anodic Stripping Voltammetry (ASV)
ASV is used to determine metals and metalloids at trace levels. It involves two steps: deposition and stripping. First, a negative potential is applied to the...
Volatilization
Sample Preparation for Analysis: Advanced Techniques
Acid digestion with strong acids is commonly used to dissolve inorganic materials that are insoluble (do not dissolve) in water. This method can be useful for...