Related Experiment Video

Updated: Aug 16, 2025

Advanced Compositional Analysis of Nanoparticle-polymer Composites Using Direct Fluorescence Imaging
07:41

Advanced Compositional Analysis of Nanoparticle-polymer Composites Using Direct Fluorescence Imaging

Published on: July 19, 2016

7.8K

Optical mapping of the evolution of water content during the swelling of hydrophilic polymers

Shasha Liu1, Yajing Gao2, Wei Wang1

  • 1State Key Laboratory of Analytical Chemistry for Life Science, Chemistry and Biomedicine Innovation Center (ChemBIC), School of Chemistry and Chemical Engineering, Nanjing University, Nanjing 210023, China. wei.wang@nju.edu.cn.

Chemical Communications (Cambridge, England)
|December 20, 2022
PubMed

More Related Videos

Methods for the Self-integration of Megamolecular Biopolymers on the Drying Air-LC Interface07:06

Methods for the Self-integration of Megamolecular Biopolymers on the Drying Air-LC Interface

Published on: April 7, 2017

6.1K
Phase Behavior of Charged Vesicles Under Symmetric and Asymmetric Solution Conditions Monitored with Fluorescence Microscopy10:08

Phase Behavior of Charged Vesicles Under Symmetric and Asymmetric Solution Conditions Monitored with Fluorescence Microscopy

Published on: October 24, 2017

9.3K

Related Concept Videos

Molecular Weight of Step-Growth Polymers01:08

Molecular Weight of Step-Growth Polymers

Step growth polymerization involves bi or multifunctional monomers. Bifunctional monomers react to form linear step growth polymers, whereas multifunctional monomers react to form non-linear or branched polymers.
As the step-growth polymerization involves step-wise condensation of monomers, the molecular weight also builds up eventually. Consequently, high molecular weight polymers are obtained at the late stages of the polymerization, where 99% of monomers have been consumed.
The extent of the...
2.3K
Polymers: Molecular Weight Distribution01:10

Polymers: Molecular Weight Distribution

For any given polymer, the weight average molecular weight (Mw) is higher than, if not equal to, the number average molecular weight (Mn). The only situation in which the weight average molecular weight and the number average molecular weight are equal is when a polymer consists only of chains with equal molecular weight. However, this never happens in a synthetic polymer, since it is difficult to control the polymerization process up to a molecular level with accuracy to a hundred percent.
3.6K