Related Experiment Video
Updated: Aug 14, 2025

Fabrication of Schottky Diodes on Zn-polar BeMgZnO/ZnO Heterostructure Grown by Plasma-assisted Molecular Beam Epitaxy
Published on: October 23, 2018
Improvement in current drivability and stability in nanoscale vertical channel thin-film transistors via band-gap
Hyun-Min Ahn1, Young-Ha Kwon2, Nak-Jin Seong2
1Department of Advanced Materials Engineering for Information and Electronics, Kyung Hee University, Yongin, Gyeonggi-do 17104, Republic of Korea.
Abstract:
Vertical channel thin film transistors (VTFTs) have been expected to be exploited as one of the promising three-dimensional devices demanding a higher integration density owing to their structural advantages such as small device footprints. However, the VTFTs have suffered from the back-channel effects induced by the pattering process of vertical sidewalls, which critically deteriorate the device reliability. Therefore, to reduce the detrimental back-channel effects has been one of the most urgent issues for enhancing the device performance of VTFTs. Here we show a novel strategy to introduce an In-Ga-Zn-O (IGZO) bilayer channel configuration, which was prepared by atomic-layer deposition (ALD), in terms of structural and electrical passivation against the back-channel effects. Two-dimensional electron gas was effectively employed for improving the operational reliability of the VTFTs by inducing strong confinement of conduction electrons at heterojunction interfaces. The IGZO bilayer channel structure was composed of 3 nm-thick In-rich prompt (In/Ga = 4.1) and 12 nm-thick prime (In/Ga = 0.7) layers. The VTFTs using bilayer IGZO channel showed high on/off ratio (4.8 × 109), low SS value (180 mV dec-1), and high current drivability (13.6μAμm-1). Interestingly, the strategic employment of bilayer channel configurations has secured excellent device operational stability representing the immunity against the bias-dependent hysteretic drain current and the threshold voltage instability of the fabricated VTFTs. Moreover, the threshold voltage shifts of the VTFTs could be suppressed from +5.3 to +2.6 V under a gate bias stress of +3 MV cm-1for 104s at 60 °C, when the single layer channel was replaced with the bilayer channel. As a result, ALD IGZO bilayer configuration could be suggested as a useful strategy to improve the device characteristics and operational reliability of VTFTs.
Related Concept Videos
MOSFET: Enhancement Mode
In their basic form, enhancement-mode MOSFETs are typically non-conductive when the gate-source voltage (Vgs) is zero. This default 'off' state means no...
Characteristics of MOSFET
Various vital parameters influence their functionality, which is crucial for theory and electronics applications. First, channel dimensions, precisely length, and width, are pivotal. The size of these channels affects the transistor's ability to carry current and switching speeds; shorter channels typically enable...
MOSFET: Depletion Mode
The primary characteristic of depletion-mode MOSFETs is their ability to conduct current between the drain and source terminals without gate bias. This inherent conductivity...
Metal-Semiconductor Junctions
Schottky Barriers
Schottky barriers arise when a metal with a work function (Φm) contacts a semiconductor with a different work function (Φs). Initially, electrons transfer until the Fermi levels of the metal and semiconductor align at equilibrium. For instance, if Φm > Φs, the semiconductor Fermi level is higher than the metal's before contact. The...
Biasing of Metal-Semiconductor Junctions
In Schottky junctions, where the semiconductor is n-type, applying a positive voltage to the metal relative to the semiconductor reduces its Fermi...
Biasing of FET
In an N-channel JFET, the structure consists of N-type material forming the channel on a P-type substrate, with the...

