Signal-to-Noise Ratio Analysis for the Voltage-Mode Read-Out of Quartz Tuning Forks in QEPAS Applications

Quartz tuning forks (QTFs) are employed as sensitive elements for gas sensing applications implementing quartz-enhanced photoacoustic spectroscopy. Therefore, proper design of the QTF read-out electronics is required to optimize the signal-to-noise ratio (SNR), and in turn, the minimum detection limit of the gas concentration. In this work, we present a theoretical study of the SNR trend in a voltage-mode read-out of QTFs, mainly focusing on the effects of (i) the noise contributions of both the QTF-equivalent resistor and the input bias resistor R_L of the preamplifier, (ii) the operating frequency, and (iii) the bandwidth (BW) of the lock-in amplifier low-pass filter. A MATLAB model for the main noise contributions was retrieved and then validated by means of SPICE simulations. When the bandwidth of the lock-in filter is sufficiently narrow (BW = 0.5 Hz), the SNR values do not strongly depend on both the operating frequency and R_L values. On the other hand, when a wider low-pass filter bandwidth is employed (BW = 5 Hz), a sharp SNR peak close to the QTF parallel-resonant frequency is found for large values of R_L (R_L > 2 MΩ), whereas for small values of R_L (R_L < 2 MΩ), the SNR exhibits a peak around the QTF series-resonant frequency.