Digital Technologies Applied to Control the One-Step Process of Cannabis Olive Oil Preparations

The reproducibility of an extemporaneous preparation is an essential condition for guaranteeing the quality, efficacy, and safety of the medicinal product. This study aimed to develop a controlled one-step process for cannabis olive oil preparations by applying digital technologies. For this purpose, the chemical profile of cannabinoid contents in oil extracts of Bedrocan, FM2, and Pedanios varieties obtained with the already in use method, proposed by the Italian Society of Compounding Pharmacists (SIFAP), was compared with two new methods, specifically the Tolotto Gear^® extraction method (TGE) and the Tolotto Gear^® extraction method preceded by a pre-extraction procedure (TGE-PE). HPLC analyses showed that the concentration of THC using cannabis flos with a high THC content (over 20% w/w) was always higher than 21 mg/mL for the Bedrocan variety and close to 20 mg/mL for the Pedanios variety when applying TGE, while with TGE-PE, the THC concentration was higher than 23 mg/mL for the Bedrocan variety. For the FM2 variety, the amounts of THC and CBD in the oil formulations obtained using TGE were higher than 7 mg/mL and 10 mg/mL, respectively, and for TGE-PE, the concentrations of THC and CBD were higher than 7 mg/mL and 12 mg/mL, respectively. GC-MS analyses were performed to define the terpene contents in the oil extracts. The samples of Bedrocan flos extracted with TGE-PE displayed a distinctive profile, highly rich in terpenes and devoid of oxidized volatile products. Thus, TGE and TGE-PE allowed performing a quantitative extraction of cannabinoids and increasing the total mono-di-tri terpenes and sesquiterpene concentrations. The methods were repeatable and applicable to any quantity of raw material, preserving the phytocomplex of the plant.