Related Experiment Video
Updated: Aug 4, 2025

Calcium Carbonate Formation in the Presence of Biopolymeric Additives
Published on: May 14, 2019
Ionothermal Synthesis of Novel Layered Magnesium Phosphate and its Tribological Properties as Grease additives
Xiaosheng Zhang1, Xiaoqi Xu1, Xiaoya Wu1
1Shanxi Key Laboratory of Chemical Product Engineering, College of Chemical Engineering and Technology, Taiyuan University of Technology, Taiyuan, 030024, Shanxi (P. R., China.
Abstract:
A novel layered magnesium phosphate (MgP) was synthesised from a MgO-P2 O5 -choline chloride-oxalic acid dihydrate system using an ionothermal approach. Single crystal samples of MgP were obtained following introduction of diethylamine (DEA) to the reaction system. Its structure revealed that both the layer and the sheets contained Mg octahedra. Interestingly, adding the layered material to lithium grease resulted in superior lubrication with higher load-carrying, anti-wear and friction reduction capacities compared with the typical lubricant MoS2 ; the PB value of base grease was increased from 353 to 1078 and 549 N, the wear scar diameter was decreased from 0.50 to 0.34 and 0.46 mm, and the friction coefficient was decreased from 0.082 to 0.056 and 0.075, respectively. We also discuss the lubrication mechanism of layered materials based on the crystal structure and resource endowment. The findings could assist the development of new high-efficiency solid lubricants.
Related Concept Videos
Design Example: Deciding Thickness of Lubricating Fluid in a Shaft
To calculate the required thickness of the lubricant layer, the tangential velocity at the shaft's surface must first be determined. This velocity is calculated by converting the rotational speed to angular...
Journal Bearings
To better understand the concept of journal bearings, consider a rope winch with dry or...

