Related Experiment Video
Updated: Jul 29, 2025

Low-cost Custom Fabrication and Mode-locked Operation of an All-normal-dispersion Femtosecond Fiber Laser for Multiphoton Microscopy
Published on: November 22, 2019
A Low-Phase-Noise 8 GHz Linear-Band Sub-Millimeter-Wave Phase-Locked Loop in 22 nm FD-SOI CMOS
Mamady Kebe1, Mihai Sanduleanu2
1School of Electrical Engineering and Computer Science (EECS), University of Ottawa, Ottawa, ON K1N 6N5, Canada.
Abstract:
Low-phase noise and wideband phased-locked loops (PLLs) are crucial for high-data rate communication and imaging systems. Sub-millimeter-wave (sub-mm-wave) PLLs typically exhibit poor performance in terms of noise and bandwidth due to higher device parasitic capacitances, among other reasons. In this regard, a low-phase-noise, wideband, integer-N, type-II phase-locked loop was implemented in the 22 nm FD-SOI CMOS process. The proposed wideband linear differential tuning I/Q voltage-controlled oscillator (VCO) achieves an overall frequency range of 157.5-167.5 GHz with 8 GHz linear tuning and a phase noise of -113 dBc/Hz @ 100 KHz. Moreover, the fabricated PLL produces a phase noise less than -103 dBc/Hz @ 1 KHz and -128 dBc/Hz @ 100 KHz, corresponding to the lowest phase noise generated by a sub-millimeter-wave PLL to date. The measured RF output saturated power and DC power consumption of the PLL are 2 dBm and 120.75 mW, respectively, whereas the fabricated chip comprising a power amplifier and an integrated antenna occupies an area of 1.25 × 0.9 mm2.
Related Concept Videos
Time and frequency -Domain Interpretation of Phase-lead Control
The design of phase-lead control involves the strategic placement of poles and zeros to balance steady-state error and system...
Phase-lead and Phase-lag Controllers
Small-Signal Analysis of MOSFET Amplifiers
MOSFET Amplifiers
MOSFET: Enhancement Mode
In their basic form, enhancement-mode MOSFETs are typically non-conductive when the gate-source voltage (Vgs) is zero. This default 'off' state means no...
Time and frequency -Domain Interpretation of Phase-lag Control
Phase-lag controllers do not place a pole at zero, but instead influence the steady-state error by amplifying any...

