Ultra-low-loss 5-LP mode selective coupler based on fused biconical taper technique

Trapped in the stringent adiabatic transmission condition of high-order modes, low-loss fused biconical taper mode selective coupler (FBT-MSC) has long been challenging to achieve. We identify the adiabatic predicament of high-order modes to stem from the rapid variation of the eigenmode field diameter, which is caused by the large core-cladding diameter difference of few-mode fiber (FMF). We demonstrate that introducing a positive-index inner cladding in FMF is an effective approach to address this predicament. The optimized FMF can be used as dedicated fiber for FBT-MSC fabrication, and exhibits good compatibility with the original fibers, which is critical for the wide adoption of MSC. As an example, we add inner cladding in a step-index FMF to achieve excellent adiabatic high-order mode characteristics. The optimized fiber is used to manufacture ultra-low-loss 5-LP MSC. The insertion losses of the fabricated LP₀₁, LP₁₁, LP₂₁, LP₀₂ and LP₁₂ MSCs are 0.13 dB at 1541 nm, 0.02 dB at 1553 nm, 0.08 dB at 1538 nm, 0.20 dB at 1523 nm, and 0.15 dB at 1539 nm, respectively, with smoothly varying insertion loss across the wavelength domain. Additional loss is less than 0.20 dB from 1465.00 nm to 1639.31 nm, and the 90% conversion bandwidth exceeds 68.03 nm, 166.68 nm, 174.31 nm, 132.83 nm, and 84.17 nm, respectively. MSCs are manufactured using commercial equipment and a standardized process that takes just 15 minutes, making them a potential candidate for low-cost batch manufacturing in a space division multiplexing system.