Integral back-stepping active disturbance rejection control for piezoelectric stick-slip drive nanopositioning stage
Keping Liu1,2, Shuai Yu1, Zhenguo Zhang3
1School of Electrical and Electronic Engineering, Changchun University of Technology, Changchun, China.
Abstract:
Piezoelectric stick-slip driven nanopositioning stage (PSSNS) with nanometer resolution has been widely used in the field of micro-operation. However, it is difficult to achieve nanopositioning over large travel, and its positioning accuracy is affected by the hysteresis characteristics of the piezoelectric elements, external uncertain disturbances, and other nonlinear factors. To overcome the above-mentioned problems, a composite control strategy combining stepping mode and scanning mode is proposed in this paper, and an integral back-stepping linear active disturbance rejection control (IB-LADRC) strategy is proposed in the scanning mode control phase. First, the transfer function model of the system in the micromotion part was established, and then the unmodeled part of the system and the external disturbance were treated as the total disturbance and extended to a new system state variable. Second, a linear extended state observer was used as the core of the active disturbance rejection technique to estimate displacement, velocity, and total disturbance in real time. In addition, by introducing virtual control variables, a new control law was designed to replace the original linear control law and improve the positioning accuracy and robustness of the system. Furthermore, the effectiveness of the IB-LADRC algorithm was verified by simulation comparison experiments and experimentally validated on a PSSNS. Finally, experimental results show that the IB-LADRC is a practical solution for a controller capable of handling disturbances during the positioning of a PSSNS with a positioning accuracy of less than 20 nm, which essentially remains constant under load.
More Related Videos
09:18Measurement of Extracellular Ion Fluxes Using the Ion-selective Self-referencing Microelectrode Technique
Published on: May 3, 2015
11:44Real-Time DC-dynamic Biasing Method for Switching Time Improvement in Severely Underdamped Fringing-field Electrostatic MEMS Actuators
Published on: August 15, 2014
Related Concept Videos
PI Controller: Design
Time-Domain Interpretation of PD Control
Consider the example of control of motor torque. Initially, a positive...
Time and frequency -Domain Interpretation of PI Control
Acting as a low-pass filter, the PI controller slows the system's response and extends settling times. This requires...
PD Controller: Design
Designing a continuous-data controller requires selecting and linking components like adders and integrators, which are fundamental in Proportional,...
