Quantification of trace fenuron in waste water samples by matrix matching calibration strategy and gas
Sude Oflu1, Sezin Erarpat1, Buse Tuğba Zaman1
1Yıldız Technical University, Faculty of Art and Science, Department of Chemistry, 34210, Davutpasa, Esenler, Istanbul, Turkey.
Abstract:
This study presents a highly sensitive and accurate analytical strategy for the determination of fenuron in wastewater samples using gas chromatography-mass spectrometry (GC-MS). Simultaneous derivatization and spray-based fine droplet formation-liquid phase microextraction (SFDF-LPME) method was developed and performed to achieve low detection limits. The parameters of the derivatization and SFDF-LPME method were optimized by univariate approach to improve sensitivity and selectivity. Under the optimum SFDF-LPME-GC-MS conditions, the limit of detection (LOD) and limit of quantitation (LOQ) were found to be 0.15 and 0.49 mg/kg, respectively. In addition, the linear range was calculated as 0.51-24.50 mg/kg. Recovery studies were carried out on wastewater samples to determine the accuracy of the developed method and its applicability to real sample matrix. Matrix matching calibration strategy was applied to eliminate/reduce any possible interference effects caused by the complexity of the wastewater matrix and to increase the accuracy of the analytical results. Percent recovery results varied between 85.9 and 120.9% with small percent relative standard deviation values. These results were satisfactory in terms of the accuracy and applicability of the proposed method for wastewater samples.
Related Concept Videos
Gas Chromatography: Types of Detectors-II
Gas Chromatography: Types of Detectors-I
TCD is the earliest and most widely used detector that operates by measuring the changes in the thermal conductivity of the carrier gas. When a sample compound enters the detector,...
Gas Chromatography: Overview of Detectors
A non-destructive detector allows a sample to be analyzed without altering or consuming it, meaning the sample can be collected after detection for further analysis. Examples include thermal conductivity detectors and...


