Testing the Influence of Laser Pulse Energy and Rate in the Atom Probe Tomography Analysis of Minerals

The use of atom probe tomography (APT) for mineral analysis is contributing to fundamental studies in Earth Sciences. Meanwhile, the need for standardization of this technique is becoming evident. Pending the use of mineral standards, the optimization of analysis parameters is needed to facilitate the study of different mineral groups in terms of data collection and quality. The laser pulse rate and energy are variables that highly affect the atom evaporation process occurring during APT analysis, and their testing is important to forecast mineral behavior and obtain the best possible data. In this study, five minerals representative of major groups (albite, As-pyrite, barite, olivine, and monazite) were analyzed over a range of laser pulse energies (10-50 pJ) and rates (100-250 kHz) to assess output parameter quality and evaluate compositional estimate stoichiometry. Among the studied minerals, As-pyrite, with the higher thermal conductivity and lower band gap, was the most affected by the laser pulse variation. Chemical composition estimates equal or close to the general chemical formula were achieved for monazite and As-pyrite. The analysis of multihit events has proved to be the best strategy to verify the efficacy of the evaporation process and to evaluate the best laser pulse setting for minerals.