Evaluation of the Depth and Width of Cuts after Controlled-Depth Abrasive Water Jet Machining Using Low Pressure

The presented paper is focused on the evaluation of material removal during machining via an abrasive water jet with a controlled depth of cut. In the introductory parts of the work, a theoretical analysis of water jet technology and an analysis of the current state of the problem are presented. The experimental part of the work is devoted to testing the effects of technological parameters on material removal from the point of view of the maximum erosion depth and volume loss of material during machining with a low water pressure of 50 MPa. The tested material was a Ti 6Al 4V titanium alloy. The experiments were carried out by changing the traverse speed of the cutting head, the mass flow of the abrasive and the angle of inclination of the cutting head, according to the DoE 3³ experiment plan. The obtained values were evaluated using the method of variance (ANOVA) and regression analysis. Furthermore, the values of the width of the erosion track and the maximum and minimum erosion effects for both tested materials were evaluated.