Related Experiment Video

Updated: Jun 27, 2025

Development of New Methods for Quantifying Fish Density Using Underwater Stereo-video Tools
09:32

Development of New Methods for Quantifying Fish Density Using Underwater Stereo-video Tools

Published on: November 20, 2017

9.2K

A comparative study of satellite altimetry-based and DEM-based methods for estimating lake water volume changes

Haotian Li1, Jun Chen2, Liguo Cao3

  • 1Engineering Research Center of Building Energy Efficiency Control and Evaluation, Ministry of Education, Hefei, China; School of Environmental and Energy Engineering, Anhui Jianzhu University, Hefei, China.

Water Science and Technology : a Journal of the International Association on Water Pollution Research
|April 28, 2024
PubMed

Keywords:
ChinaDAHITISRTM DEMlakewater volume

More Related Videos

Investigating the Relationship between Sea Surface Chlorophyll and Major Features of the South China Sea with Satellite Information10:28

Investigating the Relationship between Sea Surface Chlorophyll and Major Features of the South China Sea with Satellite Information

Published on: June 13, 2020

5.8K
Continuous Hydrologic and Water Quality Monitoring of Vernal Ponds06:37

Continuous Hydrologic and Water Quality Monitoring of Vernal Ponds

Published on: November 13, 2017

9.2K

Related Concept Videos

Design Example: Measuring Distance Between Two Points with Obstructions01:10

Design Example: Measuring Distance Between Two Points with Obstructions

When measuring distances in areas with physical obstructions, such as a lake in a field, surveyors must employ techniques to calculate accurate lengths without direct line measurements. One effective method is the offset technique, which allows for precise distance estimation over inaccessible stretches.In this scenario, a surveyor must measure a side of an area that crosses a lake. Since the measuring tape cannot span the lake, the surveyor begins by establishing a baseline that aligns with...
34
Introduction and Methods of Leveling01:26

Introduction and Methods of Leveling

Leveling is a surveying procedure used to determine elevation differences between distant points. Elevation refers to the vertical distance above or below a reference datum, typically mean sea level (MSL). In the United States, elevations are often referenced to the mean sea level station at Father Point Rimouski along the St. Lawrence Seaway. To make the datum accessible, permanent markers are established throughout the region. These markers, called benchmarks, have known elevations. If the...
97
Methods of Obtaining Topography01:25

Methods of Obtaining Topography

Topography involves measuring and mapping land elevations, natural features, and artificial structures to create accurate representations of the terrain. Topographic surveying relies on traditional and modern methods, each with distinct advantages and limitations.Traditional Surveying Methods:Transit stadia surveys and plane table surveys were widely used traditional surveying methods. These techniques relied on instruments like theodolites and stadia rods for measuring distances and angles,...
63
Gravimetry: Overview01:05

Gravimetry: Overview

Gravimetric analysis is a quantitative method where the analyte is isolated and weighed directly or after conversion into a substance of known composition. Gravimetric analysis can be classified as precipitation, electrogravimetry, volatilization, and particulate gravimetry, based on the method used to isolate the analyte.
In precipitation gravimetry, the analyte is converted into a precipitate and weighed. For example, the silver content in a sample can be estimated by precipitating and...
5.6K
Typical Model Studies01:30

Typical Model Studies

Fluid mechanics model studies often utilize scaled-down systems to predict fluid behavior in full-scale environments, such as river flows, dam spillways, and structures interacting with open surfaces. Maintaining Froude number similarity in river models is crucial, as it replicates surface flow features like wave patterns and velocities.
356
Modeling and Similitude01:12

Modeling and Similitude

Scaled modeling is a fundamental technique in engineering, enabling the study of large and complex systems by creating smaller, manageable replicas that recreate critical characteristics of the original. In hydrology and civil infrastructure, for example, scaled models of dams help analyze water flow, turbulence, and pressure. This method allows for accurate predictions of real-world behavior within a controlled environment, significantly reducing the cost and time involved in full-scale...
263