Decomposition of HCN during Experimental Impacts in Dry and Wet Planetary Atmospheres

Antonín Knížek1, Lukáš Petera1,2, Vojtěch Laitl1,3

  • 1J.Heyrovský Institute of Physical Chemistry, Czech Academy of Sciences, Dolejškova 2155/3, CZ18223 Prague, Czech Republic.

ACS Earth & Space Chemistry
|June 26, 2024
PubMed

Related Concept Videos

Aldehydes and Ketones with HCN: Cyanohydrin Formation Mechanism01:10

Aldehydes and Ketones with HCN: Cyanohydrin Formation Mechanism

Cyanohydrins are formed when cyanide nucleophiles and carbonyl compounds like aldehydes and ketones react. A strong base, the cyanide ion, catalyzes cyanohydrin formation. The ions are generated from HCN under aqueous conditions. Once the cyanide ions are generated, the first step involves the nucleophilic attack of the cyanide ions on the electrophilic carbonyl carbon. This attack shifts the π electrons from the C=O to the oxygen atom forming the alkoxide ion intermediate. The alkoxide anion...
3.1K
Chemical Ionization (CI) Mass Spectrometry01:21

Chemical Ionization (CI) Mass Spectrometry

The molecular ion peak of a molecule in the mass spectrum provides vital information for molecular identification. However, conventional electron impact ionization can lead to the rapid dissociation of some molecular ions before they reach the detector. A milder ionization method is required to increase the lifetime of such ionized analyte molecules. Chemical ionization (CI) is a gas-phase protonation reaction useful for mass-analyzing analyte molecules that are easily protonated to yield the...
726
Aldehydes and Ketones with HCN: Cyanohydrin Formation Overview01:32

Aldehydes and Ketones with HCN: Cyanohydrin Formation Overview

Cyanohydrins are compounds that contain –CN and –OH groups on the same carbon atom. They are formed by the nucleophilic addition of the cyanide ions to the carbonyl group. Cyanide ions are highly basic and nucleophilic and can be generated from HCN under aqueous conditions. However, since HCN is a weak acid, the number of cyanide ions generated is very small. Hence, a small amount of base or KCN/NaCN is added to HCN to increase the concentration of the cyanide ions in the reaction...
2.7K
Inductively Coupled Plasma–Mass Spectrometry (ICP–MS): Overview01:19

Inductively Coupled Plasma–Mass Spectrometry (ICP–MS): Overview

In inductively coupled plasma–mass spectrometry (ICP–MS), an inductively coupled plasma (ICP) torch is used as an atomizer and ionizer. Solid samples are dissolved and volatilized before being introduced into the high-temperature argon plasma, while solution samples are nebulized and passed through the high-temperature argon plasma. Plasma dissociates the analytes and ionizes their component atoms to form a mixture of positive ions and molecular species. The positive ions are then...
700
Washing, Drying, and Ignition of Precipitates00:52

Washing, Drying, and Ignition of Precipitates

After filtration, the precipitate is washed to remove coprecipitated impurities and any remaining mother liquor. Colloidal precipitates, such as silver chloride, are washed with an electrolyte (such as dilute nitric acid) to prevent the peptization of the precipitate. In the case of slightly soluble precipitates, the wash solution contains a common ion to reduce solubility. Lead sulfate, which is slightly soluble in water, is washed with dilute sulfuric acid. Similarly, wash solutions may be...
905
Hess's Law03:40

Hess's Law

There are two ways to determine the amount of heat involved in a chemical change: measure it experimentally, or calculate it from other experimentally determined enthalpy changes. Some reactions are difficult, if not impossible, to investigate and make accurate measurements for experimentally. And even when a reaction is not hard to perform or measure, it is convenient to be able to determine the heat involved in a reaction without having to perform an experiment.
45.0K