Effect of Temperature on CO2 Adsorption onto Amine-Functionalized KIT-6 Adsorbents
Mariana Suba1, Orsina Verdeș1, Silvana Borcănescu1
1Coriolan Drăgulescu Institute of Chemistry, Mihai Viteazul No.24, 300223 Timișoara, Romania.
Abstract:
The mesoporous silica KIT-6 was synthesized and functionalized with 3-aminopropyltriethoxysilane (APTES) by grafting at 110 °C. The composites were prepared with three different concentrations of APTES: 20, 30 and 40 wt.%. The as-prepared samples were characterized by thermal gravimetric analysis in air and nitrogen atmosphere (TG/DTA), Fourier transform infrared spectroscopy (FT-IR), X-ray diffraction and nitrogen adsorption-desorption. In this study, CO2 adsorption-desorption was investigated using temperature programmed desorption mass spectrometry (TPD-MS) at different temperatures. The adsorption capacity of the prepared composites is 2.23 mmol CO2/g at 40 °C and decreases to 0.95 mmol/g at 70 °C. Regarding the efficiency of the amino groups, the best result was obtained for APTES-grafted KIT-6 at 40 °C, with 0.512 mmol CO2/mmol NH2. The results showed good cyclical stability in adsorption capacities even after nine adsorption-desorption cycles.
More Related Videos
09:46Adsorption Device Based on a Langatate Crystal Microbalance for High Temperature High Pressure Gas Adsorption in Zeolite H-ZSM-5
Published on: August 25, 2016
08:00Author Spotlight: Standardizing the Development of Amine-Based Silica Composites as CO2 Adsorbents for Direct Air Capture
Published on: September 29, 2023
Related Concept Videos
02:28Effect of Temperature Change on Reaction Rate
01:27Atomic Spectroscopy: Effects of Temperature
At thermal equilibrium, the relative populations of excited and ground state atoms can be estimated using the Maxwell–Boltzmann distribution. For example, an increase in temperature...
02:55Temperature Dependence on Reaction Rate
Atoms, molecules, or ions must collide before they can react with each other. Atoms must be close together to form chemical bonds. This premise is the basis for a theory that explains many observations regarding chemical kinetics, including factors affecting reaction rates.
The collision theory is based on the postulates that (i) the reaction rate is proportional to the rate of reactant collisions, (ii) the reacting species collide in an orientation allowing contact between...
02:19Physical Properties Affecting Solubility
As for any solution, the solubility of a gas in a liquid is affected by the attractive intermolecular forces between solute and solvent species. Unlike solid and liquid solutes, however, there is no solute-solute intermolecular attraction to overcome when a gaseous solute dissolves in a liquid solvent since the atoms or molecules comprising a gas are far separated and experience negligible interactions. Consequently, solute-solvent interactions are the sole...
02:34Arrhenius Plots
The Arrhenius equation can be used...
01:13Introduction to Mechanisms of Enzyme Catalysis