Comparison of 1- and 3-piece directly 3-dimensional printed indirect bonding trays: An in vitro study
Related Experiment Video
Updated: Jun 14, 2025
Author Spotlight: Real-Time Imaging of Bonding in 3D-Printed Layers
Published on: September 1, 2023
Merve Nur Eglenen1, Gülden Karabiber2
1Department of Orthodontics, Faculty of Dentistry, Yeditepe University, Kadiköy, Istanbul, Turkey.
Introduction:
This study aimed to compare the transfer accuracy of indirect bonding trays of different thicknesses and numbers of pieces.
Methods:
Digital indirect bonding was performed on 56 printed resin models, divided into 4 groups with 14 models in each: 1-mm 1-piece tray (OPT), 2-mm OPT, 1-mm 3-piece tray (TPT), and 2-mm TPT. The trays were designed using Appliance Designer (3Shape A/S, Copenhagen, Denmark). Angular (torque, tip, or angulation) and linear (mesiodistal, buccolingual, occlusogingival, or vertical) differences were compared by using open-source GOM Inspect software (GOM GmbH, Braunschweig, Germany).
Results:
In the buccolingual direction, the 1-mm TPT (0.180 ± 0.041 mm) was significantly more accurate than the 1-mm OPT (0.240 ± 0.032 mm). In the vertical direction, significant differences were seen between the 1-mm and 2-mm OPTs (1-mm OPT: 0.220 ± 0.043 mm; 2-mm OPT: 0.428 ± 0.143 mm; P = 0.003) and between the 1-mm and 2-mm TPTs (1-mm TPT: 0.210 ± 0.072 mm; 2-mm TPT: 0.340 ± 0.062 mm; P = 0.004) in the total region. In the tip angle, significant differences were seen between the 1-mm and 2-mm OPTs and between the 1-mm OPT and TPT. In the torque angle, a significant difference was seen between the 1-mm TPT (2.815°±0.350°)and 2-mmTPT (2.368° ± 0.245°; P = 0.017).
Conclusions:
Both the thickness and the splitting of the trays impacted the bracket bonding accuracy. The 1-mm trays were more accurate than the 2-mm trays. Despite a few statistically significant differences between the 1-mm OPT and TPT, the 1-mm OPT was recommended for clinical use, considering the designing and placing of the trays.
