Related Experiment Video

Updated: Jun 11, 2025

Standard Test Method ASTM D 7998-19 for the Cohesive Strength Development of Wood Adhesives
08:40

Standard Test Method ASTM D 7998-19 for the Cohesive Strength Development of Wood Adhesives

Published on: May 17, 2020

2.9K

Bio-Epoxy Resins Based on Lignin and Tannic Acids as Wood Adhesives-Characterization and Bonding Properties

Ivana Gavrilović-Grmuša1, Milica Rančić1, Tamara Tešić1

  • 1Faculty of Forestry, University of Belgrade, 11030 Belgrade, Serbia.

Polymers
|September 28, 2024
PubMed

Keywords:
bio-epoxidesbio-hardenerepoxy ligninlignintannic acidtensile shear strength

More Related Videos

Preparation and Testing of Plant Seed Meal-based Wood Adhesives08:09

Preparation and Testing of Plant Seed Meal-based Wood Adhesives

Published on: March 5, 2015

8.7K
Quantitative 31P NMR Analysis of Lignins and Tannins05:57

Quantitative 31P NMR Analysis of Lignins and Tannins

Published on: August 2, 2021

12.3K

Related Concept Videos

Wood Products01:21

Wood Products

Wood products encompass a broad range of materials crafted from wood strands, veneers, lumber, and even waste wood-like shreds, designed for both structural and nonstructural purposes. Various specialized wood products have been developed to enhance strength, durability, and versatility in building applications.
Glue-laminated wood, often referred to as glulam, combines multiple smaller pieces of dimensional lumber using adhesives to form a single, larger piece. Cross-laminated timber consists...
79
Structural Properties and Dimensions of Lumber01:21

Structural Properties and Dimensions of Lumber

Wood's structural properties derive from fibers aligned along the tree's length, contributing significantly to its mechanical strength. Wood exhibits up to twenty times greater tensile strength along these fibers compared to across them, and generally shows better performance under compression than tension. The length of fibers varies, with hardwoods having fibers around one twenty-fifth inch long and softwoods ranging from one-eighth to one-third inch.
The strength characteristics of...
80
Wood Panel Products01:18

Wood Panel Products

Wood panel products are essential materials used in construction for applications such as flooring, siding, and roofing, typically available in standard dimensions of 4 feet by 8 feet, with thicknesses varying from one-quarter of an inch to one and one-eighth inches. Among the most common types of wood panels is plywood, which is produced by gluing multiple layers of thin wood veneers under pressure. The grain of the outer veneers runs lengthwise, while the grains of the interior layers run...
70
Introduction to Wood01:19

Introduction to Wood

Wood, derived from trees, is a versatile and widely used construction material. Trees feature a trunk surrounded by a protective layer of dead bark. Beneath this outer layer lies the living bark, followed by the cambium, and then the sapwood which transitions into heartwood as it matures. At the center of the trunk is the pith. The age of a tree can be discerned by examining its growth rings, which are concentric bands visible in the trunk's cross-section.
The structural integrity of the...
209
Cell Adhesion in Plants01:14

Cell Adhesion in Plants

Plants have rigid cell walls that are made up of cell wall polysaccharides that mediate cell-cell adhesion. The primary cell walls of plants consist of two independent and interacting polysaccharide networks: a pectin matrix that embeds the second network comprising cellulose and hemicelluloses.
Pectins are complex heteropolymers mainly composed of negatively-charged α-D-glucopyranosyl uronic acid and some neutral glycosyl residues such as α-L-rhamnopyranose, α-L-arabinofuranose,...
2.6K