Related Experiment Video
Updated: Jun 6, 2025

A Uniaxial Compression Experiment with CO2-Bearing Coal Using a Visualized and Constant-Volume Gas-Solid Coupling Test System
Published on: June 12, 2019
Study on the characteristics of dust diffusion during a truck travelling in an open-pit coal mine affected by the
Wendong Zhou1, Yanwei Cui2, Hetang Wang3
1School of Emergency Management, Nanjing University of Information Science & Technology, Nanjing 210044, China; State Key Laboratory for Fine Exploration and Intelligent Development of Coal Resource, China University of Mining and Technology, Xuzhou 221116, China; School of Safety Engineering, China University of Mining and Technology, Xuzhou 221116, China.
Abstract:
Heavy trucks in open-pit mines are significant sources of dust. The diffusion of dust is primarily influenced by wind flow. The surface wind speed exhibits an exponential distribution as height increases. To investigate dust diffusion under the influence of wind shear, a numerical model was developed using real-scale data through computational fluid dynamics. The results indicate that wind shear significantly affects near-ground wind speeds. The ground-level wind speed near the rear of the truck exceeds the dust lift-off speed, reaching over 6 m/s. The acceleration of the ambient wind speed leads to extensive areas of turbulence with increased intensity. The location of the vortex zone represents the primary area of negative pressure. A higher ambient wind speed accelerates the dust discharge and generates a greater negative pressure, reaching -68 Pa at a wind speed of 9 m/s. The dust concentration behind the truck initially increases before subsequently decreasing. Notably, the local dust concentration at a wind speed of 9 m/s is lower than that at a wind speed of 5 m/s. The obstruction of airflow by the truck cab can result in elevated dust levels on the driver's side. Furthermore, high dust concentrations along driving paths necessitate appropriate truck spacing to protect operator health.
More Related Videos
10:29Experimental Methodology for Estimation of Local Heat Fluxes and Burning Rates in Steady Laminar Boundary Layer Diffusion Flames
Published on: June 1, 2016
13:27Exploring the Effects of Atmospheric Forcings on Evaporation: Experimental Integration of the Atmospheric Boundary Layer and Shallow Subsurface
Published on: June 8, 2015
Related Concept Videos
Characteristics of Dry Friction
Before the wheelbarrow starts moving, the static frictional force acts tangentially to the contact surface, opposing the force that is about to induce the motion. This frictional force prevents the...
Boundary Layer Characteristics
Design Example: Calculating Safe Diameter for Wind-Exposed Disc
Diffusion on Chromatography Columns
Longitudinal diffusion occurs when the solute molecules in the mobile phase diffuse from the more concentrated center of the chromatographic band to the more dilute regions on either side, both towards and against the flow direction. This...