Related Experiment Video
Updated: Aug 9, 2026
Mimicking and Measuring Occlusal Erosive Tooth Wear with the "Rub&Roll" and Non-contact Profilometry
Published on: February 2, 2018
COMPARATIVE ANALYSIS OF ENAMEL SURFACE WEAR INDUCED BY TWO CONCENTRATIONS OF ZIRCONIA PARTICLE TOOTHPASTE UNDER TWO
Z Lila1, S Krasniqi2, A Gjelaj3
11Department of Prosthodontics, Medical Faculty, University of Prishtina "Hasan Prishtina", Pristina, Kosovo.
Background:
Dental enamel, the outermost layer of human teeth, is a mineralized tissue that must endure repetitive forces, wear, and corrosion resulting from everyday oral activities like chewing. Its high mineral content provides the strength and hardness necessary for proper tooth function. However, over time, wear, fractures, or cavities often lead to the need for dental repairs. Additionally, unlike other human tissues, dental enamel lacks significant regenerative or self-repair capabilities, making tooth restorations more essential.
Objective:
To evaluate the effects of two electric toothbrush modalities and two different concentrations of zirconia-containing whitening toothpaste on enamel surface roughness.
Materials And Methods:
Forty extracted lower third molars were divided into four groups based on toothpaste concentration (3% and 4% zirconia) and brushing mode (active and soft). Each tooth was brushed for 5 minutes using an oscillating electric toothbrush. Enamel surface roughness was measured before and after brushing using a contact profilometer.
Results:
Brushing with 4% zirconia toothpaste in active mode resulted in the highest increase in enamel surface roughness, particularly in Rz and Rq values. Conversely, the soft mode, especially with 4% zirconia toothpaste, demonstrated a protective trend, where post-brushing roughness values decreased in some metrics. However, these changes did not reach statistical significance across any group (p>0.05).
Conclusion:
While higher concentrations of zirconia in whitening toothpaste and increased brushing force may influence enamel surface roughness, the observed changes were not statistically significant. Further research is needed to determine safe concentrations and brushing techniques to minimize enamel wear.
