Related Experiment Video
Updated: Sep 14, 2025

An Efficient Clearing Protocol for the Study of Seed Development in Tomato Solanum lycopersicum L.
Published on: September 7, 2022
Influence of physical shape and salting on tomato drying performance using mixed mode solar and open-air methods in
Abdallah Elshawadfy Elwakeel1, Guma Ali2,3, Abdalla Zain Eldin4
1Agricultural Engineering Department, Faculty of Agriculture and Natural Resources, Aswan University, Aswân, 81528, Egypt. abdallah_elshawadfy@agr.aswu.edu.eg.
Abstract:
SD Solar drying is increasingly recognized as a sustainable and energy-efficient solution for preserving agricultural products, offering a practical alternative to fossil fuel-dependent methods and traditional open sun drying (OSD). However, its overall performance is highly influenced by environmental variability and system design. This study provides a detailed evaluation of a newly developed direct solar dryer (DDSD) for tomato dehydration, conducted under real and fluctuating climatic conditions in Aswan, Egypt, from February 22 to 27, 2025. During the trial period, solar irradiance ranged widely from 88 to 826 W/m2 due to intermittent cloud cover, while ambient temperatures fluctuated between 22 and 34 °C-conditions representative of actual field environments. Tomato samples were prepared in three physical forms-halves, quarters, and 6 mm slices-and subjected to two pretreatment methods (salted and unsalted) to assess their effects on drying kinetics. The DDSD demonstrated significantly better performance than OSD, reducing drying durations by 25-39.6%. The most efficient results were achieved for salted 6 mm slices, which dried in just 9 h-substantially faster than the 29 h for unsalted halves in DDSD and 48 h in OSD. These samples also exhibited the highest effective moisture diffusivity (Deff) (5.92 × 10⁻⁹ m2/s), reflecting enhanced internal moisture transport. Among 12 drying models evaluated, the Logistic model most accurately described the drying behavior in the DDSD, with an excellent statistical fit (R2 = 0.999524, χ2 = 6.74 × 10⁻5, RMSE = 0.006868). Economically, the DDSD, integrated with a photovoltaic (PV) system, required a modest initial investment of $520 and achieved a payback period of just 1.82 years for salted slices due to faster processing and increased throughput. From an environmental perspective, the system is projected to offset approximately 105.68 metric tons of CO₂ emissions over a 20-year lifespan, with an energy payback time of only 1.10 years and potential revenue of $1321.04 from carbon credits. These findings underscore the DDSD's potential as a cost-effective, environmentally sustainable, and technically efficient solution for agricultural drying in solar-rich regions.
More Related Videos
07:07Controlled-release of Chlorine Dioxide in a Perforated Packaging System to Extend the Storage Life and Improve the Safety of Grape Tomatoes
Published on: April 7, 2017
06:49In situ Grazing Incidence Small Angle X-ray Scattering on Roll-To-Roll Coating of Organic Solar Cells with Laboratory X-ray Instrumentation
Published on: March 2, 2021
Related Concept Videos
Drying Shrinkage
A portion of this drying shrinkage can be reversed; if the concrete is...
Masonry in Cold and Hot Weather Conditions
Other key practices include keeping masonry units...
Moisture Content and Bulking of Aggregate
When aggregates are exposed to rain or sit in stockpiles, they absorb moisture, which must be...
Regulation of Transpiration by Stomata