Learning-Based Fault-Tolerant Optimal Formation Control of Helicopters: An Incremental Fully Actuated System Approach
Abstract:
To elevate the robustness and optimality of helicopter formation, this article proposes the incremental fully actuated system approach (FASA) integrated with reinforcement learning (RL) for the formation control of multiple helicopters with faulty swash plates. First, the helicopter model encompassing aerodynamics, flapping dynamics, and swash plate dynamics under actuator faults is established. Then, the entire helicopter formation is reinterpreted and stabilized by the incremental FASA that offers the replacement of model information, the suppression of lumped uncertainty, and the rearrangement of system dynamics, with mitigated reliance on model accuracy and computing resources. Next, considering the influence of the actuator faults of a single helicopter on the convergence of the entire formation, RL is applied to pursue the optimal control strategy against fault impact through the critic network, which updates along the dynamics revised by the incremental FASA, ensuring satisfactory formation performance throughout the flight, augmenting the cost efficiency of the control scheme, and relieving any means of identification or approximation on helicopter dynamics. Finally, the stability of the control scheme is proved, and numerical simulations are conducted to illustrate it is efficiency.
Related Concept Videos
Controller Configurations
Control-system compensation involves various configurations, most commonly series or cascade compensation, in which the controller...
Feedback control systems
Linear feedback systems are theoretical models that simplify analysis and design. These systems operate under the principle that their output is directly proportional to their input within certain ranges. For instance, an amplifier in a control system behaves linearly as long as the input signal remains within a specific range. However, most physical systems exhibit inherent nonlinearity...
Open and closed-loop control systems
An open-loop control system operates without feedback from the output. It consists of two primary elements: the controller and the controlled process. The controller receives an input signal...
Control Systems
At the heart...
Lift
Application of Linearization and Approximation


