Related Experiment Video
Updated: Feb 6, 2026

Direct and Indirect Culture Methods for Studying Biodegradable Implant Materials In Vitro
Published on: April 15, 2022
Effect of Bioceramic-Based Obturation Techniques on the Amount of Residual Filling Material after Retreatment: An In
Sara Wael Nour1, Abeer Abd Elhakim Elgendy2, Amr Ahmed Bayoumi1
1Endodontics Division, Department of Conservative Dentistry, Faculty of Dentistry, Misr International University, Cairo, Egypt.
Objectives:
The aim of this article is to quantitatively assess the amount and distribution of residual filling after retreatment of root canals obturated with a bioceramic sealer using three obturation techniques: single-cone technique (SCT), warm vertical compaction (WVC), and cold lateral compaction (CLC).
Materials And Methods:
Forty-two mandibular premolars were prepared up to size F4 and randomly assigned to SCT, WVC, or CLC (n = 14/group). All canals were obturated with a bioceramic sealer. After storage for 15 days at 37 °C, retreatment was performed using the ProTaper Universal Retreatment (PTUR) without solvent. Roots were sectioned longitudinally, and residual fillings in coronal, middle, and apical thirds were quantified using stereomicroscopy and analyzed with ImageJ. Intra-examiner reliability was assessed using intraclass correlation coefficients.
Statistical Analysis:
Nonparametric Kruskal-Wallis test was used to compare residual filling percentages among the three techniques, followed by pairwise comparisons with the Mann-Whitney U-test. Statistical significance was set at α = 0.05.
Results:
No statistically significant differences were observed among the three obturation techniques in the percentage of remaining fillings (p = 0.0657). SCT exhibited the highest percentage of residuals (86.31 ± 14.49%), and CLC the lowest (62.66 ± 31.90%). All techniques exhibited a progressive increase in residuals toward the apical third.
Conclusion:
None of the obturation techniques allowed complete removal of bioceramic-based fillings after retreatment with PTUR. Although differences were not statistically significant, CLC was associated with the lowest amount of residuals, whereas SCT exhibited the highest. The apical third remained the most challenging region to clean across all techniques.
Related Concept Videos
Residual Plots
When the residual values are plotted against the variable x, it is called a residual...
Residual Stresses
Residual Stresses in Circular Shafts
Residual Stresses in Bending
Residuals and Least-Squares Property
If the observed data point lies above the line, the residual is positive, and the line underestimates the actual data value for y. If the observed data point lies below the line, the residual is negative, and the line overestimates the actual data value for y.
The process of fitting the best-fit...
Members Made of Elastoplastic Material
As the bending moment...

