Related Experiment Video

Updated: Feb 21, 2026

Rapid Repetition Rate Fluctuation Measurement of Soliton Crystals in a Microresonator
07:42

Rapid Repetition Rate Fluctuation Measurement of Soliton Crystals in a Microresonator

Published on: December 15, 2021

3.6K

Kerr soliton dynamics and deterministic generation in microresonators: joint effects of chirped pulse parameters,

Elham Barati, Seyed Masuod Jazayeri, Mahdi Shayganmanesh

    Optics Express
    |February 20, 2026
    PubMed

    More Related Videos

    Stimulated Stokes and Antistokes Raman Scattering in Microspherical Whispering Gallery Mode Resonators12:21

    Stimulated Stokes and Antistokes Raman Scattering in Microspherical Whispering Gallery Mode Resonators

    Published on: April 4, 2016

    11.7K
    Microwave Photonics Systems Based on Whispering-gallery-mode Resonators12:18

    Microwave Photonics Systems Based on Whispering-gallery-mode Resonators

    Published on: August 5, 2013

    17.6K

    Related Concept Videos

    Double Resonance Techniques: Overview01:12

    Double Resonance Techniques: Overview

    Double resonance techniques in Nuclear Magnetic Resonance (NMR) spectroscopy involve the simultaneous application of two different frequencies or radiofrequency pulses to manipulate and observe two distinct nuclear spins. One important application of double resonance is spin decoupling, which selectively suppresses coupling with one type of nucleus while observing the NMR signal from another nucleus, simplifying the spectrum and enhancing resolution.
    Spin decoupling is usually achieved by...
    792
    IR Spectrum Peak Splitting: Symmetric vs Asymmetric Vibrations01:08

    IR Spectrum Peak Splitting: Symmetric vs Asymmetric Vibrations

    Identical bonds within a polyatomic group can stretch symmetrically (in-phase) or asymmetrically (out-of-phase). Similar to hydrogen bonding, these vibrations also influence the shape of the IR peak. Generally, asymmetric stretching frequencies are higher than symmetric stretching frequencies. For example, primary amines exhibit two distinct IR peaks between 3300–3500 cm−1 corresponding to the symmetric and asymmetric N-H stretching, while secondary amines exhibit a single...
    1.9K
    Standing Waves in a Cavity01:28

    Standing Waves in a Cavity

    A household microwave and lasers are examples of standing electromagnetic waves in a cavity. When two conducting metal plates are placed parallel at the nodal planes, it creates a cavity where standing waves are formed. The cavity between the two planes is analogous to a stretched string held at the points x = 0 and x = L. Here, the distance 'L' between the two planes must be an integer multiple of half of the wavelength. The wavelengths that satisfy this condition are given by:
    1.5K
    ¹H NMR: Interpreting Distorted and Overlapping Signals01:02

    ¹H NMR: Interpreting Distorted and Overlapping Signals

    Spin systems where the difference in chemical shifts of the coupled nuclei is greater than ten times J are called first-order spin systems. These nuclei are weakly coupled, and their chemical shifts and coupling constant can generally be estimated from the well-separated signals in the spectrum.
    As Δν decreases and the signals move closer, the doublets appear increasingly distorted. The intensities of the inner lines increase at the cost of those of the outer lines as the signals are...
    1.6K
    Sound Waves: Resonance01:14

    Sound Waves: Resonance

    Resonance is produced depending on the boundary conditions imposed on a wave. Resonance can be produced in a string under tension with symmetrical boundary conditions (i.e., has a node at each end). A node is defined as a fixed point where the string does not move. The symmetrical boundary conditions result in some frequencies resonating and producing standing waves, while other frequencies interfere destructively. Sound waves can resonate in a hollow tube, and the frequencies of the sound...
    3.5K
    NMR Spectrometers: Radiofrequency Pulses and Pulse Sequences01:17

    NMR Spectrometers: Radiofrequency Pulses and Pulse Sequences

    A pulse is a short burst of radio waves distributed over a range of frequencies that simultaneously excites all the nuclei in the sample. Upon passing a radio frequency pulse along the x-axis, the nuclei absorb energy corresponding to their Larmor frequencies and achieve resonance. This shifts the net magnetization vector from the z-axis toward the transverse plane. This angle of rotation of the magnetization vector, or the flip angle, is proportional to the duration and intensity of the pulse.
    1.9K