Mechanical Performance and Artificial Aging Behavior of Reinforced 3D-Printed PLA Structures for Drone Arm...

This study addresses several key limitations identified in previous research on additively manufactured PLA composites. Unlike most earlier studies that focused primarily on the characterization of as-printed materials, the present work systematically investigates both mechanical and surface behavior before, during, and after artificial aging. In addition, six different printing configurations and reinforcement types (PVC and fiberglass mesh) were analyzed under controlled conditions, enabling a more reliable assessment of their combined influence on composite performance. Printed specimens were artificially aged for 45 and 90 days. The aging protocol combined cyclic changes in moisture, temperature, UV, and IR agents, trying to mimic real exploitation conditions as realistically as possible. The chemical and surface changes during aging were tracked using FTIR spectroscopy, colorimetry, contact angle, and surface free energy measurements. Mechanical performance at 0, 45, and 90 days was evaluated through tensile, three-point bending, and Charpy impact tests, as well as full-scale cantilever loading tests of real printed drone arms. Results show that artificial aging causes measurable chemical and surface modifications, as indicated by changes in the FTIR degradation index and surface wettability. However, these changes do not result in severe mechanical degradation within the investigated aging period. Reinforcement in the form of incorporated PVC and fiberglass mesh significantly affected failure behavior. Specimens printed with higher infill density and thicker infill lines generally exhibit improved mechanical properties. Specimens stiffness and impact resistance were also altered. Results demonstrate that reinforced PLA structures are suitable for lightweight drone applications.