Electrospark Deposition and Ultrasonic Peening Treatment on AlSi10Mg Powder Bed Fusion-Laser Beam Parts:...

Additive manufacturing (AM) has revolutionized industrial production. However, the repair of AM components remains a critical challenge due to their unique microstructural features. While repair approaches for conventionally manufactured alloys are well established, their direct transferability to AM parts remains largely unexplored due to the unique thermal history and anisotropic microstructure of additive components. This study investigates a novel repair and improvement strategy for Powder Bed Fusion-Laser Beam/Metal (PBF-LB/M)-fabricated AlSi10Mg components, combining Electrospark Deposition (ESD) for dimensional restoration with subsequent Ultrasonic Peening Treatment (UPT) for surface enhancement. Microstructure, porosity, surface roughness, hardness profiles, residual stresses, and corrosion behaviour were systematically characterized using SEM, optical microscopy, profilometry, Vickers microhardness testing, XRD, and electrochemical polarization tests. The results show that the ESD process is capable of producing coatings with excellent interfacial adhesion to the substrate, with an initial porosity of 3.6 ± 0.5%. The subsequent UPT induces a significant densification effect on the deposited material, reducing porosity by approximately 50% and increasing surface hardness by up to 48% in the upper region of the coating. Furthermore, XRD analysis reveals that UPT completely reverses the residual stress state from tensile (typical of the ESD process) to compressive in all measured directions, thereby improving the overall structural integrity. Ultimately, the combined ESD + UPT alters the electrochemical response of AlSi10Mg deposits, resulting in a nobler corrosion potential, albeit with a slightly higher corrosion current density.