Related Experiment Video

Updated: Jun 17, 2026

[(DPEPhos)(bcp)Cu]PF6: A General and Broadly Applicable Copper-Based Photoredox Catalyst
09:12

[(DPEPhos)(bcp)Cu]PF6: A General and Broadly Applicable Copper-Based Photoredox Catalyst

Published on: May 21, 2019

Cooperative Ir(III)/Ni(II) catalysis in a photoactive molecular amine cage for visible-light-induced aerobic

Lipei Cui1, Zhuolin Shi1, Hanshu Li1

  • 1Central Hospital of Dalian University of Technology, School of Chemistry, State Key Laboratory of Fine Chemicals, Dalian University of Technology, Dalian 116024, China. xuezhaoli@dlut.edu.cn.

Chemical Communications (Cambridge, England)
|June 16, 2026
PubMed

More Related Videos

Developing Photosensitizer-Cobaloxime Hybrids for Solar-Driven H2 Production in Aqueous Aerobic Conditions10:21

Developing Photosensitizer-Cobaloxime Hybrids for Solar-Driven H2 Production in Aqueous Aerobic Conditions

Published on: October 5, 2019

A Microwave-Assisted Direct Heteroarylation of Ketones Using Transition Metal Catalysis07:06

A Microwave-Assisted Direct Heteroarylation of Ketones Using Transition Metal Catalysis

Published on: February 16, 2020

Related Concept Videos

Cycloaddition Reactions: MO Requirements for Photochemical Activation01:12

Cycloaddition Reactions: MO Requirements for Photochemical Activation

Some cycloaddition reactions are activated by heat, while others are initiated by light. For example, a [2 + 2] cycloaddition between two ethylene molecules occurs only in the presence of light. It is photochemically allowed but thermally forbidden.
Photochemical Electrocyclic Reactions: Stereochemistry01:26

Photochemical Electrocyclic Reactions: Stereochemistry

The absorption of UV–visible light by conjugated systems causes the promotion of an electron from the ground state to the excited state. Consequently, photochemical electrocyclic reactions proceed via the excited-state HOMO rather than the ground-state HOMO. Since the ground- and excited-state HOMOs have different symmetries, the stereochemical outcome of electrocyclic reactions depends on the mode of activation; i.e., thermal or photochemical.
Selection Rules: Photochemical Activation
Reactions of Aldehydes and Ketones: Baeyer–Villiger Oxidation01:22

Reactions of Aldehydes and Ketones: Baeyer–Villiger Oxidation

Baeyer–Villiger oxidation converts aldehydes to carboxylic acids and ketones to esters. The reaction uses peroxy acids or peracids and is often catalyzed by acid. The reaction is named after its pioneers, Adolf von Baeyer and Victor Villiger. The reaction is achieved by a wide range of peracids such as m-chloroperoxybenzoic acid (mCPBA), perbenzoic acid (C6H5COOOH), peracetic acid (CH3COOOH), hydrogen peroxide (H2O2), and tert-butyl hydroperoxide (t-BuOOH).
The carbonyl center is activated by...
Alkynes to Aldehydes and Ketones: Hydroboration-Oxidation02:47

Alkynes to Aldehydes and Ketones: Hydroboration-Oxidation

Introduction
One of the convenient methods for the preparation of aldehydes and ketones is via hydration of alkynes. Hydroboration-oxidation of alkynes is an indirect hydration reaction in which an alkyne is treated with borane followed by oxidation with alkaline peroxide to form an enol that rapidly converts into an aldehyde or a ketone. Terminal alkynes form aldehydes, whereas internal alkynes give ketones as the final product.
Aldehydes and Ketones with Amines: Imine Formation Mechanism01:23

Aldehydes and Ketones with Amines: Imine Formation Mechanism

Imine formation involves the addition of carbonyl compounds to a primary amine. It begins with the generation of carbinolamine through a series of steps involving an initial nucleophilic attack and then several proton transfer reactions. The second part includes the elimination of water, as a leaving group, to give the imine.
Imines are formed under mildly acidic conditions. A pH of 4.5 is ideal for the reaction.
If the pH is low or the solution is too acidic, the reaction slows down in the...
α-Hydroxy Ketones via Reductive Coupling of Esters: Acyloin Condensation Overview01:19

α-Hydroxy Ketones via Reductive Coupling of Esters: Acyloin Condensation Overview

The pinacol and McMurry reactions involve the reductive coupling of ketones or aldehydes. Similarly, the bimolecular reductive coupling of two ester molecules in the presence of sodium metal in an aprotic solvent yields an α-hydroxy ketone product. The α-hydroxy ketone is also called acyloin, so the reaction is referred to as ‘acyloin condensation.’