Structure of the myosin projections on native thick filaments from vertebrate skeletal muscle

Rabbit psoas muscle filaments, isolated in relaxing buffer from non-glycerinated muscle, have been applied to hydrophilic carbon films and stained with uranyl acetate. Electron micrographs were obtained under low-dose conditions to minimize specimen damage. Surrounding the filament backbone, except in the bare zone, is a fringe of clearly identifiable myosin heads. Frequently, both heads of individual myosin molecules are seen, and sometimes a section of the tail can be seen connecting the heads to the backbone. About half the expected number of heads can be counted, and they are uniformly distributed along the filament. The majority of heads appear curved. The remainder could be curved heads viewed from another aspect. Three times as many heads curve in a clockwise sense than in an anticlockwise sense, suggesting a preferential binding of one side of the head to the carbon film. The two heads of myosin molecules exhibit all the possible combinations of clockwise, anticlockwise and straight heads, and analysis of their relative frequencies suggests that the heads rotate freely and independently. The heads also adopt a wide range of angles of attachment to the tail. The lengths of heads cover a range of 14 to 26 nm, with a peak at 19 nm. The average maximum width is 6.5 nm. Both measurements are in excellent agreement with values for shadowed molecules. Since our data are from heads adsorbed to the film in relaxing conditions and the shadowed molecules were free of nucleotide, gross shape changes are not likely to be produced by nucleotide binding. The length of the link between the heads and the backbone was found to vary between 10 nm and 52 nm, with a broad peak at about 25 nm. Thus, the hinge point detected in the tail of isolated molecules was not usually the point from which the crossbridges swung out from the filament surface. The angle made by the link to the filament axis was between 20 degrees and 80 degrees, with a broad maximum around 45 degrees. These lengths and angles concur with our observation of an average limit of the crossbridges from the filament surface of 30 nm. This is sufficient to enable heads in the myofibril lattice to reach out beyond the nearest thin filament and should allow considerable flexibility for stereospecific binding to actin in active muscle.