Related Experiment Video
Updated: Aug 15, 2026

Real-time Visualization and Analysis of Chondrocyte Injury Due to Mechanical Loading in Fully Intact Murine Cartilage Explants
Published on: January 7, 2019
Dynamic fracture characteristics of the osteochondral junction undergoing shear deformation
N D Broom1, A Oloyede, R Flachsmann
1Department of Mechanical Engineering, University of Auckland, New Zealand.
Abstract:
This paper presents a biomechanical study of the dynamic fracture response of the osteochondral regions of both immature and mature cartilage-bone laminates induced through shear loading. An instrumental impact machine, providing both mechanical and real-time macro-photographic fracture data, was used to load the osteochondral region in shear by means of a direct compressive force applied to the cartilage layer only, and in a direction parallel to the plane of the osteochondral junction. This force was applied at a known velocity of 2500 mm/s. Our results show that under these conditions of shear loading the dynamic mode II fracture toughness of the osteochondral region of the mature tissue is approximately 1.5 times that of its immature counterpart, and that the derived dynamic shear stiffness of the immature tissue is about 4 times that of the mature. The structural studies demonstrated that the mature tissue delaminates within a well-defined tidemark region whilst the immature fractures through the subchondral bone into which fingers of articular cartilage penetrate. We suggest that this pseudo-brittleness of the immature tissue could explain why there is an increased susceptibility to osteochondral failure in the younger human joint. Finally, we note that the strength-to-toughness relationship, in which stiffer engineering materials are known to exhibit lower fracture toughness, also applies to the cartilage-bone system.
Related Concept Videos
Fractures: Bone Repair
Minor fractures with no bone displacement are treated by immobilizing the fractured bone using a cast or splint. However, in the case of fractures with displaced bones, the broken bones are repositioned before immobilization to ensure successful healing without deformation and loss of function. The realignment of fractured bone ends is performed through a process called reduction. If the procedure...
Shearing Stress
The average shearing stress can be calculated by dividing the shear by the area of the cross-section.
Shearing Strain
Relation between Poisson's ratio, Modulus of Elasticity and Modulus of Rigidity
Deformation in a Circular Shaft
Plastic Deformation in Circular Shafts

