Comparison of diaphyseal growth between the Libben Population and the Hamann-Todd chimpanzee sample

S W Simpson1, K F Russell, C O Lovejoy

  • 1Department of Anatomy, Case Western Reserve University School of Medicine, Cleveland, Ohio 44106, USA.

Related Concept Videos

Growth of Cartilage and Bone Tissue01:27

Growth of Cartilage and Bone Tissue

Chondrocytes form a temporary cartilaginous model by dividing and secreting a thick gel-like extracellular matrix. Once the chondrocytes undergo programmed cell death, osteoblasts enter the site of the cartilaginous model. The process of replacing the temporary cartilaginous model with bone in an ordered manner is called endochondral ossification. In endochondral ossification, not all of the cartilage is replaced by bone tissue. Some cartilage that performs a protective and supportive function...
Changes in the Appendicular Skeleton with Age01:09

Changes in the Appendicular Skeleton with Age

The upper and lower limb initially develops as a small bulge called a limb bud, which appears on the lateral side of the early embryo. The upper limb bud appears near the end of the fourth week of development, with the lower limb bud appearing shortly after.
Initially, the limb buds consist of a core of mesenchyme covered by a layer of ectoderm. The ectoderm at the end of the limb bud thickens to form a narrow crest called the apical ectodermal ridge. This ridge stimulates the underlying...
Testing a Claim about Mean: Unknown Population SD01:21

Testing a Claim about Mean: Unknown Population SD

A complete procedure of testing a hypothesis about a population mean when the population standard deviation is unknown is explained here.
Estimating a population mean requires the samples to be approximately normally distributed. The data should be collected from the randomly selected samples having no sampling bias. There is no specific requirement for sample size. But if the sample size is less than 30, and we don't know the population standard deviation, a different approach is used; instead...
Wald-Wolfowitz Runs Test II01:17

Wald-Wolfowitz Runs Test II

The Wald-Wolfowitz runs test, commonly referred to as the runs test, is a nonparametric test used to assess the randomness of ordered data. The test evaluates the number of runs, which are consecutive sequences of similar elements within the data. If the number of runs is significantly higher or lower than expected, the data is considered non-random, indicating a detectable pattern or structure.
For binary data, runs are identified using symbols such as + and −, or equivalently, 1s and 0s. In...