Related Experiment Video
Updated: Aug 6, 2026

Cooling Rate Dependent Ellipsometry Measurements to Determine the Dynamics of Thin Glassy Films
Published on: January 26, 2016
A direct comparison of surface and bulk chain-relaxation in polystyrene
Wen-Li Wu1, Sharadha Sambasivan, Chia-Ying Wang
1Polymers Division, National Institute of Standards and Technology, 100 Bureau Drive, Gaithersburg, MD 20899-8541, USA. wenli@nist.gov
Abstract:
Near-edge X-ray absorption fine-structure (NEXAFS) spectroscopy was used to measure simultaneously the relaxation rates of polystyrene (PS) molecules at the free surface and in the bulk. The samples were uniaxially stretched and annealed at temperatures below the bulk glass transition temperature of PS. The surface and bulk chain relaxation was monitored by measuring the partial-electron and the fluorescence NEXAFS yields, respectively, both parallel and perpendicular to the stretching direction. The decay of the optical birefringence was also measured to provide an independent measure of the bulk relaxation. Relaxation of PS chains was found to occur faster on the surface relative to the bulk. The magnitude of the surface glass transition temperature suppression over the bulk was estimated based on the information on the temperature dependence of the rates.
More Related Videos
06:55Synthesis of Cyclic Polymers and Characterization of Their Diffusive Motion in the Melt State at the Single Molecule Level
Published on: September 26, 2016
11:27Studying Soft-matter and Biological Systems over a Wide Length-scale from Nanometer and Micrometer Sizes at the Small-angle Neutron Diffractometer KWS-2
Published on: December 8, 2016
Related Concept Videos
¹H NMR of Conformationally Flexible Molecules: Temporal Resolution
Polymer Classification: Architecture
Polymer Classification: Stereospecificity
Radical Chain-Growth Polymerization: Chain Branching
Molecular Weight of Step-Growth Polymers
As the step-growth polymerization involves step-wise condensation of monomers, the molecular weight also builds up eventually. Consequently, high molecular weight polymers are obtained at the late stages of the polymerization, where 99% of monomers have been consumed.
The extent of the...
Determination of Molar Masses of Polymers I