Related Experiment Video
Updated: Jul 11, 2026

Sit-to-stand-and-walk from 120% Knee Height: A Novel Approach to Assess Dynamic Postural Control Independent of Lead-limb
Published on: August 30, 2016
Intrinsic joint kinematic planning. II: hand-path predictions based on a Listing's plane constraint
D G Liebermann1, A Biess, C C A M Gielen
1Department of Physical Therapy, Sackler Faculty of Medicine, Tel-Aviv University, 69978, Ramat Aviv, Israel. dlieberm@post.tau.ac.il
Abstract:
This study was aimed at examining the assumption that three-dimensional (3D) hand movements follow specific paths that are dictated by the operation of a Listing's law constraint at the intrinsic joint level of the arm. A kinematic model was used to simulate hand paths during 3D point-to-point movements. The model was based on the assumption that the shoulder obeys a 2D Listing's constraint and that rotations are about fixed single-axes. The elbow rotations were assumed to relate linearly to those of the shoulder. Both joints were assumed to rotate without reversals, and to start and end rotating simultaneously with zero initial and final velocities. Model predictions were compared to experimental observations made on four right-handed individuals that moved toward virtual objects in "extended arm", "radial", and "frontal plane" movement types. The results showed that the model was partially successful in accounting for the observed behavior. Best hand-path predictions were obtained for extended arm movements followed by radial ones. Frontal plane movements resulted in the largest discrepancies between the predicted and the observed paths. During such movements, the upper arm rotation vectors did not obey Listing's law and this may explain the observed discrepancies. For other movement types, small deviations from the predicted paths were observed which could be explained by the fact that single-axis rotations were not followed even though the rotation vectors remained within Listing's plane. Dynamic factors associated with movement execution, which were not taken into account in our purely kinematic approach, could also explain some of these small discrepancies. In conclusion, a kinematic model based on Listing's law can describe an intrinsic joint strategy for the control of arm orientation during pointing and reaching movements, but only in conditions in which the movements closely obey the Listing's plane assumption.
Related Concept Videos
Kinematic Equations: Problem Solving
Functional Classification of Joints
The functional classification of joints is determined by the amount of mobility between the adjacent bones. Joints are functionally classified as a synarthrosis or immobile joint, an amphiarthrosis or slightly moveable joint, or as a diarthrosis, a freely moveable joint. Fibrous and cartilaginous joints can be functionally classified as either synarthroses or amphiarthroses, whereas all synovial joints are classified as diarthroses.
Synarthrosis
An immobile...
Structural Classification of Joints
A fibrous joint is where the adjacent bones are united by fibrous connective...
Method of Joints: Problem Solving II
Planar Rigid-Body Motion
Planar motion is typically divided into three distinct categories. The first is rectilinear translation, demonstrated by a subway train that moves along...
Absolute Motion Analysis- General Plane Motion
As the drone's propellers rotate, an upward force is generated that counteracts the force of gravity, enabling the drone to lift off from the ground. This initial movement of the drone is along a straight path, representing a form of translational motion. In this phase, every point on the drone...

