Related Experiment Video
Updated: Jul 5, 2026

Quantitative Detection of DNA-Protein Crosslinks and Their Post-Translational Modifications
Published on: April 21, 2023
Detection and quantitation of radiolabeled proteins and DNA in gels and blots
1Iowa State University, Ames, Iowa.
Abstract:
This appendix presents procedures for visualizing and quantitating radiolabeled proteins or DNA separated by polyacrylamide gel electrophoresis or affixed to filter membranes. Autoradiography is the most common method by which this is accomplished; X-ray film is the traditional recording medium. Film images can be analyzed by densitometry as described to obtain a quantitative measure of the radioactivity in the sample. The use of X-ray films for autoradiography, however, suffers from lack of sensitivity and limited linear range. Protocols are provided for overcoming these limitations using fluorography and intensifying screens, both of which enhance the radioactive signal. Sensitivity and linear ranges of measurement can be greatly extended by using a phosphor imaging system, which also makes it much faster and easier to quantify radioactive samples.
Related Concept Videos
Southern Blot
Denatured DNA fragments must be transferred onto a carrier membrane from the gel to make it accessible to a probe - a small ssDNA fragment complementary to the target DNA...
Two-dimensional Gel Electrophoresis
The first dimension separation uses the isoelectric focusing or IEF technique performed on immobilized pH gradient (IPG) strips that separate proteins according to their isoelectric points.
Biological samples, such as cells...
Western Blotting
The technique begins with separating proteins from the sample using sodium dodecyl sulfate-polyacrylamide gel electrophoresis (SDS-PAGE), followed by protein transfer, immunoblotting, and finally, protein detection.
Labeling DNA Probes
Radioisotopes, fluorophores, or small molecule binding partners like biotin or digoxigenin, are the most widely used reporter tags for labeling DNA probes. These labels can be attached to the probe DNA molecule via...
DNA Agarose Gel Electrophoresis
Gel extraction follows five major steps: running gel electrophoresis to separate fragments, isolating the individual bands, extracting DNA from those bands, and removing the dye and salts from the extracted mixture to obtain pure DNA.
In cloning experiments, both the insert and vector DNA...
SDS-PAGE
A variation of gel electrophoresis, termed polyacrylamide gel electrophoresis (PAGE), is commonly used for separating proteins according to their molecular size by passing them through a polyacrylamide gel. Because of the varying charges associated with amino acid side chains, PAGE can be used to separate intact proteins...

