Categorized or continuous? Strength of an association--and linear regression

In statistics, correlation describes the degree of association between two variables. In the subfield of linear regression, correlation is mathematically expressed by the correlation coefficient, which describes the strength and direction of the relationship between two variables. The coefficient is symbolically represented by 'r' and ranges from -1 to +1. A positive value indicates a positive correlation where the two variables move in the same direction. A negative value suggests a negative...

A variable, usually notated by capital letters such as X and Y, is a characteristic or measurement that can be determined for each member of a population. Data are the actual values of variables. They may be numbers, or they may be words. Datum is a single value.
Data are classified based on whether they are measurable or not. Categorical data cannot be measured; instead, it can be divided into categories. For example, if Y denotes a person's party affiliation, some examples of Y include...

Linearity is a system property characterized by a direct input-output relationship, combining homogeneity and additivity.
Homogeneity dictates that if an input x(t) is multiplied by a constant c, the output y(t) is multiplied by the same constant. Mathematically, this is expressed as:

In signal processing, signals are classified based on various characteristics: continuous-time versus discrete-time, periodic versus aperiodic, analog versus digital, and causal versus noncausal. Each category highlights distinct properties crucial for understanding and manipulating signals.
A continuous-time signal holds a value at every instant in time, representing information seamlessly. In contrast, a discrete-time signal holds values only at specific moments, often denoted as x(n), where...

Continuous-time systems have continuous input and output signals, with time measured continuously. These systems are generally defined by differential or algebraic equations. For instance, in an RC circuit, the relationship between input and output voltage is expressed through a differential equation derived from Ohm's law and the capacitor relation,

The vertical distance between the actual value of y and the estimated value of y. In other words, it measures the vertical distance between the actual data point and the predicted point on the line
If the observed data point lies above the line, the residual is positive, and the line underestimates the actual data value for y. If the observed data point lies below the line, the residual is negative, and the line overestimates the actual data value for y.
The process of fitting the best-fit...