EVALUATION OF A NEW MEAN SCALED AND MOMENT ADJUSTED TEST STATISTIC FOR SEM

Xiaoxiao Tong1, Peter M Bentler

  • 1UNIVERSITY OF CALIFORNIA, LOS ANGELES.

Structural Equation Modeling : a Multidisciplinary Journal
|February 19, 2013
PubMed

Related Concept Videos

Testing a Claim about Standard Deviation01:19

Testing a Claim about Standard Deviation

A complete procedure to test a claim about population standard deviation or population variance is explained here.
The hypothesis testing for the claim of population standard deviation (or variance) requires the data and samples to be random and unbiased. The population distribution also must be normal. There is no specific requirement on the sample size as the estimation is based on the chi-square distribution.
As a first step, the hypothesis (null and alternative) concerning the claim about...
Behrens–Fisher Test00:57

Behrens–Fisher Test

The Behrens-Fisher test is a statistical method designed to address the Behrens-Fisher problem, which arises when comparing the means of two normally distributed populations with unequal variances. Unlike the Student's t-test, which assumes equal variances, the Behrens-Fisher test allows for mean comparison without this restrictive assumption. This flexibility makes it particularly valuable in scenarios where two independent samples exhibit normality but lack variance homogeneity.
This test is...
Testing a Claim about Mean: Unknown Population SD01:21

Testing a Claim about Mean: Unknown Population SD

A complete procedure of testing a hypothesis about a population mean when the population standard deviation is unknown is explained here.
Estimating a population mean requires the samples to be approximately normally distributed. The data should be collected from the randomly selected samples having no sampling bias. There is no specific requirement for sample size. But if the sample size is less than 30, and we don't know the population standard deviation, a different approach is used; instead...
Comparing Experimental Results: Student's t-Test01:09

Comparing Experimental Results: Student's t-Test

The t-test is a statistical method used to compare the sample mean with a population mean or compare two means from two data sets. The test statistic is calculated from the standard deviation, mean, and number of measurements in the data set at a selected confidence interval and then compared to a table of critical values at this confidence level. If the test statistic is smaller than the critical value, the null hypothesis is accepted. In this case, we state that the difference between the...
McNemar's Test01:23

McNemar's Test

McNemar's Test is a nonparametric statistical test used to determine if there is a significant difference in proportions between two related groups when the outcome is binary (e.g., yes/no, success/failure). It is beneficial when we have paired data, such as pre-test/post-test designs, where the same subjects are measured under two different conditions. The test is named after the statistician Quinn McNemar, who introduced it in 1947. It is commonly used in situations where subjects are...
Standard Error of the Mean01:13

Standard Error of the Mean

The sampling variability of a statistic is defined as how much the statistic varies from one sample to another. The sampling variability of a statistic is typically measured by measuring its standard error.The standard error of the mean is an example of a standard error. It is a unique standard deviation known as the standard deviation of the sampling distribution of the mean. The standard error of the mean is a statistic that calculates how correctly a sample distribution represents a...