Body armour: the effect of load, exercise and distraction on landing forces

Paddy C Dempsey1, Phil J Handcock, Nancy J Rehrer

  • 1a School of Physical Education, Sport and Exercise Sciences , University of Otago , Dunedin , New Zealand.

Journal of Sports Sciences
|September 21, 2013
PubMed

Related Concept Videos

Impact Loading01:19

Impact Loading

Impact loading occurs when a moving object collides with a stationary structure, such as a rod with a uniform cross-sectional area fixed at one end. Under these conditions, the rod absorbs the kinetic energy from the striking object, leading to deformation and subsequent stress development. As the rod returns to its original position and reaches maximum stress, the absorbed energy, initially manifested as kinetic energy, transforms entirely into strain energy.
In cases of elastic deformation,...
Impulse01:13

Impulse

According to Newton’s second law of motion, the rate of change of the momentum of an object is the net external force acting on it. The total change in momentum between two timepoints thus depends on both the external force acting on it and the time over which it acts. Describing this mathematically, the total change of an object’s motion is proportional to the force vector and the time over which it is applied. This product is called impulse.
Additionally, it can be shown that the total...
Design Consideration01:22

Design Consideration

Designing a structure involves a series of considerations, primarily the material's ultimate strength, calculated through tests that measure changes under increased force until the material reaches its breaking point or limit. The ultimate load, where the material breaks, is divided by its original cross-sectional area, resulting in the ultimate normal stress or strength. The ultimate shearing stress is another significant factor taken into account.
The factor of safety is another key aspect...
Weightlessness01:01

Weightlessness

When an object is dropped, it accelerates toward the center of the Earth. If the net external force on the object is its weight, it is said to be in free fall; that is, the only force acting on the object is gravity. Galileo was instrumental in showing that, in the absence of air resistance, all objects fall with the same acceleration g. However, when objects on the Earth fall downward, they are never truly in free fall, because there is always some upward resistance force from the air acting...
Deformation of Member under Multiple Loadings01:11

Deformation of Member under Multiple Loadings

When a rod is made of different materials or has various cross-sections, it must be divided into parts that meet the necessary conditions for determining the deformation. These parts are each characterized by their internal force, cross-sectional area, length, and modulus of elasticity. These parameters are then used to compute the deformation of the entire rod.
In the case of a member with a variable cross-section, the strain is not constant but depends on the position. The deformation of an...
Plastic Behavior01:21

Plastic Behavior

A material's elastic behavior is characterized by the disappearance of stress once the load is removed, allowing the material to return to its original state. However, when stress surpasses the yield point, yielding commences, marking the onset of plastic deformation or permanent set. This change from elastic to plastic behavior is influenced by the peak stress value and the duration before the load is removed. An intriguing observation occurs when a specimen is loaded, unloaded, and reloaded.