Predicting pressure-dependent unimolecular rate constants using variational transition state theory with

Junwei Lucas Bao1, Xin Zhang2, Donald G Truhlar1

  • 1Department of Chemistry, Chemical Theory Center, and Supercomputing Institute, University of Minnesota, Minneapolis, Minnesota 55455-0431, USA. truhlar@umn.edu.

Related Concept Videos

Rate-Determining Steps03:08

Rate-Determining Steps

Relating Reaction Mechanisms
In a multistep reaction mechanism, one of the elementary steps progresses significantly slower than the others. This slowest step is called the rate-limiting step (or rate-determining step). A reaction cannot proceed faster than its slowest step, and hence, the rate-determining step limits the overall reaction rate.
The concept of rate-determining step can be understood from the analogy of a 4-lane freeway with a short-stretch of traffic-bottleneck caused due to...
39.1K
Reaction Mechanisms: Rate-limiting Step Approximation01:29

Reaction Mechanisms: Rate-limiting Step Approximation

The rate-determining step, or RDS, in a chemical reaction is the slowest step that determines the overall reaction rate. It is identified by using the observed rate law and typically involves approximation methods like the RDS approximation or the steady-state approximation.In the RDS approximation, also known as the rate-limiting-step or equilibrium approximation, the reaction mechanism consists of one or more reversible reactions near equilibrium, followed by a slower RDS, and then one or...
50
Temperature Dependence on Reaction Rate02:55

Temperature Dependence on Reaction Rate

The Collision Theory
Atoms, molecules, or ions must collide before they can react with each other. Atoms must be close together to form chemical bonds. This premise is the basis for a theory that explains many observations regarding chemical kinetics, including factors affecting reaction rates.
The collision theory is based on the postulates that (i) the reaction rate is proportional to the rate of reactant collisions, (ii) the reacting species collide in an orientation allowing contact between...
90.7K
Clausius-Clapeyron Equation02:35

Clausius-Clapeyron Equation

The equilibrium between a liquid and its vapor depends on the temperature of the system; a rise in temperature causes a corresponding rise in the vapor pressure of its liquid. The Clausius-Clapeyron equation gives the quantitative relation between a substance’s vapor pressure (P) and its temperature (T); it predicts the rate at which vapor pressure increases per unit increase in temperature.
63.9K
IR Spectroscopy: Hooke's Law Approximation of Molecular Vibration01:16

IR Spectroscopy: Hooke's Law Approximation of Molecular Vibration

A covalently bonded heteronuclear diatomic molecule can be modeled as two vibrating masses connected by a spring. The vibrational frequency of the bond can be expressed using an equation derived from Hooke's law, which describes how the force applied to stretch or compress a spring is proportional to the displacement of the spring. In this case, the atoms behave like masses, and the bond acts like a spring.
According to Hooke's law, the vibrational frequency is directly proportional to...
3.5K
The Van der Waals Equation01:26

The Van der Waals Equation

The ideal gas law is based on two simplifying assumptions: first, that there are no intermolecular attractions between gas molecules, and second, that the volume occupied by the molecules themselves is negligible compared with the volume of the container. However, these assumptions don't hold up under all conditions - specifically, at high pressures and low temperatures, as gas tends to deviate from ideal gas behavior.The van der Waals equation is an enhanced version of the ideal gas law,...
99