The modified Kostuik transilial bar technique has acceptable results in neuromuscular spinal deformity correction

Haci M Ozdemir1, Ismail Demirkale2, Mahmut Ozdemir3

  • 1Department of Orthopaedics and Traumatology, University of Health Sciences, Şişli Etfal HPRC, Istanbul.

Related Concept Videos

Bar Graph01:07

Bar Graph

A bar graph is also called a bar chart and consists of bars that are separated from each other. It either uses horizontal or vertical bars to show comparisons among categories. The bars can be rectangles, or they can be rectangular boxes (used in three-dimensional plots). One axis of the graph represents the specific categories being compared, and the other axis shows a discrete value. In this graph, the length of the bar for each category is proportional to the number or percent of individuals...
21.9K
Multiple Bar Graph01:07

Multiple Bar Graph

As the name suggests, a multiple bar graph is the same as a bar graph but has multiple bars to depict relationships between different data values. One can include as many parameters as possible. However, each parameter must have the same unit of measurement.
Each bar or column in the multiple bar graph represents a data value. These graphs are used primarily in interrelating two or more sets of data. The categories of different kinds of data are listed along the horizontal or x-axis, whereas...
9.1K
Distance Corrections01:15

Distance Corrections

To achieve precise distance measurements, especially in surveying and construction, certain corrections must be applied to account for potential sources of error like the standardization errors, temperature variations, and slope adjustments.Standardization error emerges when measurement equipment undergoes changes, such as wear, repairs, or weather impacts. To address this, surveyors compare the equipment’s readings to a standard. This process identifies any deviation that might lead to...
282
Plastic Deformations01:19

Plastic Deformations

Plastic deformation represents a fundamental concept in materials science, which explains the irreversible change in the shape of a material when it experiences stress beyond its elastic capability. This phenomenon is important in structural engineering, especially in designing and analyzing cantilever beams—structures that are securely fixed at one end and bear loads at the opposite end. When these beams are subjected to loads within their elastic range, they will return to their...
452
Plastic Deformations01:14

Plastic Deformations

It is essential to understand how structural members behave under plastic deformation when the bending stress exceeds the material's yield strength. This state of deformation permanently alters the shape of the member, in contrast to the linear elastic behavior observed before yielding. The strain at any point in the member is expressed in terms of maximum strain. Notably, the neutral axis, which coincides with the centroid during elastic bending, shifts away from the centroid under plastic...
428
Power Factor Correction01:20

Power Factor Correction

The power transmission to a factory involves the transfer of apparent power, a combination of active and reactive power. The power factor measures how effectively electrical power is converted into useful work output. The ratio of the real power (KW) that does the work to the apparent power (KVA) supplied to the circuit.
528