Related Experiment Video
Updated: Jan 25, 2026

Microwave Photonics Systems Based on Whispering-gallery-mode Resonators
Published on: August 5, 2013
Simultaneous mode-by-mode impulse response measurement of multi-mode optical systems based on linear optical sampling
Abstract:
Linear optical sampling is presented as a useful method to characterize mode-by-mode impulse responses or the spectral transfer matrix of multimode optical systems. In a two non-degenerate linear-polarization (LP) mode transmission line, which actually supported six independent spatial modes, 6 × 6 spectral transfer functions were simultaneously measured using multiplexed mode-by-mode impulse responses in series. According to the singular value analysis of the matrix, the mode-dependent loss spectrum was analyzed over a frequency bandwidth of several hundred GHz, which was determined by the spectra of the probe and reference pulses. The technique would be useful for characterizing various multi-spatial-mode fiber systems that are intensively being developed to overcome the limit in capacity of single-mode optical fibers.
Related Concept Videos
What is a Mode?
There can be more than one mode in a data set if multiple values have the same highest frequency. For instance, suppose that the Statistics exam scores of 20 students are: 50; 53; 59; 59; 63; 63; 72; 72; 72; 72; 72; 76; 78; 81; 83; 84; 84; 84; 90; 93. Here, the mode is 72, as it occurs most frequently, five times.
A data set with two modes is called bimodal. For example,...
Ventilatory Modes
There are three ventilatory modes: full support, partial support, and spontaneous. These are described below.
Full Support Modes
Full support modes include controlled mechanical ventilation, continuous mandatory...
MOSFET: Enhancement Mode
In their basic form, enhancement-mode MOSFETs are typically non-conductive when the gate-source voltage (Vgs) is zero. This default 'off' state means no...
Modes of Standing Waves: II
For a tube open at one end and closed at the other filled with air, the modes are such that there is always an antinode at the open end and a node at the closed end....
Modes of Standing Waves - I
Modes of Operations of BJT
Active Mode: The most common mode for amplification, the active mode features a forward-biased emitter-base junction and a reverse-biased base-collector junction. This setup enables electrons to be injected from the emitter to the base while blocking the majority carriers at the collector. The...

