Fault Estimation and Tolerant Control for Discrete-Time Multiple Delayed Fuzzy Stochastic Systems With Intermittent
Abstract:
This article is concerned with observer-based fault estimation (FE) and tolerant controller design for a series of discrete-time Takagi-Sugeno (T-S) fuzzy stochastic systems. There exist multiple time-varying state delays, intermittent sensor and actuator faults, nonlinear dynamics, and exogenous disturbances in the systems. Compared with the results of the existence, this approach suggested in this article is more flexible and feasible. By means of the FE information, a novel fuzzy adaptive descriptor observer is developed to obtain the error dynamics. Then, an active observer-based fault-tolerant controller is designed to stabilize the closed-loop fuzzy system. Furthermore, a set of delay-dependent sufficient conditions are provided by the fuzzy Lyapunov function with the way of linear matrix inequalities (LMIs), which has less conservatism compared with the ones of the existing observers and fault-tolerant controllers. Finally, a simulation example is shown to illustrate the advantages and effectiveness of this approach depicted in this article.
Related Concept Videos
Time-Domain Interpretation of PD Control
Consider the example of control of motor torque. Initially, a positive...
Feedback control systems
Linear feedback systems are theoretical models that simplify analysis and design. These systems operate under the principle that their output is directly proportional to their input within certain ranges. For instance, an amplifier in a control system behaves linearly as long as the input signal remains within a specific range. However, most physical systems exhibit inherent nonlinearity...
Control Systems
At the heart...
Transient and Steady-state Response
These test signals are integral in designing control systems to exhibit two key performance aspects: transient response and steady-state...
Multimachine Stability
In analyzing the system, the nodal equations represent the relationship between bus voltages, machine voltages, and machine currents. The nodal equation is given by:
State Space Representation
Consider an RLC circuit, a...


