Related Experiment Video
Updated: Oct 2, 2025

Comparison of Kinetic Characteristics of Footwork during Stroke in Table Tennis: Cross-Step and Chasse Step
Published on: June 16, 2021
Magnitude and Shape of the Forces Applied on the Foot Rest and Paddle by Elite Kayakers
Pedro Bonito1, Miguel Sousa2, Fernando José Ferreira2
1Faculty of Sport Sciences and Physical Education, University of Coimbra, 3040 Coimbra, Portugal.
Abstract:
The study aimed to investigate the magnitude and shape of the forces applied on the foot rest, foot strap, and paddle. Thirteen elite male kayakers participated in this study and performed a 2-min test simulating 500 m race pace in a kayak ergometer. Forces applied by the kayakers on the paddle, foot rest, and foot strap were measured with load cells and recorded by an electronic measuring system. The magnitude of the peak forces applied on the foot rest (left: 543.27 ± 85.93; right: 524.39 ± 88.36) approximately doubled the ones applied on the paddle (left: 236.37 ± 19.32; right: 243.92 ± 28.89). The forces on the foot strap were similar in magnitude to the paddle forces (left: 240.09 ± 74.92; right: 231.05 ± 52.01). A positive correlation was found between the peak forces applied on the foot rest and paddle on the same side (p < 0.001). When comparing the best and worst kayakers' performance, the best showed greater forces magnitudes and synchronization of the peak forces. Analyses of the force-time curves, including not only the forces applied by the kayaker on the paddle but also the ones applied on the foot rest and strap, should be considered relevant in terms of technique analyses.
Related Concept Videos
Applications of Stress
The...
Fluid Pressure over Curved Plate of Constant Width
Fluid Pressure over Flat Plate of Constant Width
The resultant force...
Indeterminate Structure
Impact Loading
In cases of elastic deformation,...
Fluid Pressure over Flat Plate of Variable Width
The pressure distribution on the plate can be calculated by determining the force that acts on a differential area strip of the plate. Thus, the magnitude of the force is equal to the...

