Low-cost, open-source 3D printed antibody dispenser for development and small-scale production of lateral flow assay...

We present a low cost, 3D printed open-source antibody dispenser that can be easily built and used for the development of lateral flow assay (LFA) strips. The fabrication of LFA strips need dispensing of antibodies or antigens in a linear fashion and commercially available dispensers typically cost from few thousands to few tens of thousands of US dollars. In this paper, an antibody dispenser was built by using 3D printed and commercially available parts, which cost no more than 30 USD. This paper presents a detailed instruction on how to assemble the printer and how to achieve a specific line width for the dispensed antibody. By using syringe needles of different gauges, line width ranging from 0.23 to 1.8 mm can be dispensed, and by varying the speed controller, the dispensing needle's speed can be varied between 2.8 and 3.8 cm/s. We demonstrate uniform dispensing of anti-C-reactive protein (CRP) antibody and anti-rabbit antibody to draw a test line and a control line, which are used for the detection of CRP. The dispenser can also be equipped with two dispensing needles to allow simultaneous dispensing of multiple reagents, which can be useful for LFA strip development.