Quality Analysis of Canola and Mustard Oil Using Fluorescence Spectroscopy

The potential of Fluorescence spectroscopy has been utilized for the quality analysis of canola and mustard oil along with the effect of heating on their molecular composition has been investigated. Laser diode at 405 nm has been employed directly to oil surface to excite both oil type samples and their emission spectra has been recorded by an in-house developed Fluorosensor. The emission spectra of both oil types unveiled that they contain carotenoids, isomers of vitamin E and chlorophylls that exhibit their fluorescence at 525 and 675/720 nm, and these can be used as markers for their quality assurance. Fluorescence spectroscopy is a fast, reliable and non-destructive analytical technique for the quality assessment of both oil types. Moreover, the effect of temperature on their molecular composition has been investigated by heating them at 110, 120, 130, 140, 150, 170, 180 and 200 °C, each sample for 30 min which was done because both oils are used for cooking and frying. On heating, the deterioration of carotenoids and isomers of vitamin E in both oil types occurred with an increase in the oxidised products. However, it was found that up to 150 °C, both oil types can be used safely for cooking/frying purpose where they do not lose much of their valuable ingredients and up to 180 °C for deep frying, both oils can be used with less deterioration and after that both deteriorated much due to rapid increase of the oxidized products. The portable Fluorosensor, therefore, proved as an excellent device for quality screening of edible oils based on carotenoids and vitamin E.