Related Experiment Video
Updated: Aug 2, 2025

Effective Analysis of Human Exposure Conditions with Body-worn Dosimeters in the 2.4 GHz Band
Published on: May 2, 2018
Four-Port 38 GHz MIMO Antenna with High Gain and Isolation for 5G Wireless Networks
Ahmed A Ibrahim1, Wael A E Ali2, Moath Alathbah3,4
1Electronics and Communications Engineering Department, Minia University, Minia 61519, Egypt.
Abstract:
In this paper, a 38 GHz 4-port multiple-input multiple-output (MIMO) antenna with considerable isolation and gain enhancement for 5G applications is introduced. The suggested antenna element is a monopole antenna composed of a circular patch with a rectangular slot etched from it and a partial ground plane is used to extend the desired frequency to operate from 36.6 GHz to 39.5 GHz with a center frequency of 38 GHz. The high isolation is achieved by arranging the four elements orthogonally and adding four stubs to reduce mutual coupling between elements at the desired frequency bands. The gain improvement is also introduced by placing a frequency selective structure (FSS) which is designed at the same frequency bands of the antenna under the suggested MIMO antenna to act as a reflector. The proposed four-element MIMO with the FSS prototype is built and tested in order to confirm the simulated results. The suggested antenna operated from 37.2 GHz to 39.2 GHz with an isolation of less than 25 dB across the obtained frequency range. The peak gain of the antenna is enhanced from 5.5 dBi to around 10 dBi by utilizing the FSS structure; furthermore, the back radiation is enhanced. The MIMO performance is validated by extracting its parameters and comparing with the simulated results. The results extracted from the simulation and the measurement show satisfactory matching along with the target band, indicating that the proposed structure could be used for 5G communications.
Related Concept Videos
MOSFET Amplifiers
Transmission Line Design Considerations
Maximum Power Transfer
By substituting the entire circuit with...
MOSFET: Enhancement Mode
In their basic form, enhancement-mode MOSFETs are typically non-conductive when the gate-source voltage (Vgs) is zero. This default 'off' state means no...
Small-Signal Analysis of MOSFET Amplifiers
Mesh Analysis for AC Circuits
The process of harmonizing these impedances begins with a clear understanding of the input and output signals. Once these signals are known, the...

