How palatal vault morphology and screw length influence the accuracy of dynamic computer-guided orthodontic miniscrew...

The aim of this study was to evaluate the influence of palatal vault morphology and screw length on the accuracy of miniscrew insertion in dynamic computer-assisted surgery (d-CAS).

Twenty-four subjects were allocated into three groups, according to their palatal vault morphology (Group A: medium; Group B: steep/high; Group C: low/flat) and the length of miniscrew used. For each subject, two miniscrews were inserted using a dynamic navigation system. To assess the accuracy of insertion, a postoperative CBCT was performed, and the pre- and post-operative scans were superimposed. Five variables were evaluated: Entry-3D, Entry-2D, Apex-3D, Apex-vertical and angular deviation. Descriptive statistics, Shapiro-wilk, Kruskal-Wallis and Dunn's tests were used for the statistical analysis. The level of significance was P ≤ 0.05.

The mean angular deviation values revealed strong discrepancies amongst the groups (Group A:7.11°±5.70°; Group B:13.30°±7.76°; Group C:4.92°±3.15°) and significant differences were found regarding the Apex-3D (P = 0.036) and angular deviations (P = 0.008). A Dunn's test revealed differences in angular deviation between the medium and high/steep palate group (P = 0.004), and between low/flat and high/steep palate group (P = 0.01) but did not confirm any significant difference in the Apex-3D parameter (Group A-B P = 0.10; Group B-C, P = 0.053; Group A-C, P = 1.00). No significant differences were found regarding the length of the miniscrews.

Palatal vault morphology is a factor that influences the accuracy of miniscrew insertion in d-CAS. In subjects with steep and high palatal vaults, insertion accuracy is lower when considering the angular deviation value. Miniscrew length does not influence accuracy.

Although computer-guided surgery assists the clinician in preventing damage to nearby anatomical structures, individual anatomical variability is a crucial variable. In subjects with a high/steep palate, greater attention should be paid during the planning phase in order to allow for a wide margin from adjacent anatomical structures to achieve better outcomes.