Related Experiment Video
Updated: Jun 13, 2025

Rapid Repetition Rate Fluctuation Measurement of Soliton Crystals in a Microresonator
Published on: December 15, 2021
Ergodic Rate Analysis of Simultaneous Transmitting and Reflecting Reconfigurable Intelligent Surface-Assisted
1College of Electronic and Information Engineering, Nanjing University of Aeronautics and Astronautics, Nanjing 210016, China.
Abstract:
In this paper, we combine simultaneous transmitting and reflecting reconfigurable intelligent surface (STAR-RIS) with rate-splitting multiple access (RSMA) technology and investigate the ergodic rate performance of an STAR-assisted RSMA system. Considering the discrete phase shifts of the STAR-RIS in practice, the downlink performance of STAR-RIS-assisted RSMA with discrete phase shifts is compared to that with continuous phase shifts. Firstly, the cumulative distribution function of signal-to-interference-plus-noise ratio (SINR) of users is analyzed. Then, the total ergodic rate of the system and its approximate closed-form solution are, respectively, derived based on the cumulative distribution function of users. The simulation results validate the effectiveness of the theoretical analysis, showing good agreement between the derived theoretical ergodic rate and the corresponding simulations. Although the system performance with discrete phase shifts is inferior to that with continuous phase shifts due to quantization errors, the performance of the continuous phase shift system is well approximated when the quantization bit of the phase shift system reaches 3 in the simulations. Additionally, the impact of the number of STAR-RIS elements on the system's performance is analyzed.
Related Concept Videos
Thermal Sigmatropic Reactions: Overview
Sigmatropic shifts are classified based on an order term [i, j ], where i and j indicate the number of atoms across which each end of the σ bond migrates. Below are examples of a [3,3] sigmatropic shift in...
Time and frequency -Domain Interpretation of Phase-lead Control
The design of phase-lead control involves the strategic placement of poles and zeros to balance steady-state error and system...
Carrier Generation and Recombination
This process is given by the generation rate G and is efficient due to the conservation of momentum between the valence band maximum and conduction band minimum.
Indirect generation involves an...
Gain
Gain:
Suppose Vin is the input and Vout is the output signal to a circuit.
Properties of DTFT I
The linearity property of DTFTs is fundamental. If two discrete-time signals are multiplied by constants a and b respectively, and then combined to...
Double Resonance Techniques: Overview
Spin decoupling is usually achieved by...

