Related Experiment Video
Updated: Jun 22, 2025
Additive Manufacturing of Functionally Graded Ceramic Materials by Stereolithography
Published on: January 25, 2019
Optimising Mg-Ca/PLA Composite Filaments for Additive Manufacturing: An Analysis of Particle Content, Size, and
Hyeonseok Kim1, Tom McKenna1, Eoin O'Cearbhaill1
1School of Mechanical and Materials Engineering, University College Dublin, D04 C1P1 Dublin, Ireland.
Abstract:
Low-temperature additive manufacturing of magnesium (Mg) alloy implants is considered a promising technique for biomedical applications due to Mg's inherent biocompatibility and 3D printing's capability for patient-specific design. This study explores the influence of powder volume content, size, and morphology on the mechanical properties and viscosity of polylactic acid (PLA) matrix composite filaments containing in-house-produced magnesium-calcium (Mg-Ca) particles, with a focus on their application towards low-temperature additive manufacturing. We investigated the effects of varying the Mg-Ca particle content in a PLA matrix, revealing a direct correlation between volume content and bending strength. Particle size analysis demonstrated that smaller particles (D50: 57 μm) achieved a bending strength of 63.7 MPa, whereas larger particles (D50: 105 μm) exhibited 49.6 MPa at 20 vol.%. Morphologically, the filament containing spherical particles at 20 vol.% showed a bending strength that was 11.5 MPa higher than that of the filament with irregular particles. These findings highlight the critical role of particle content, size, and shape in determining the mechanical and rheological properties of Mg-Ca/PLA composite filaments for use in material extrusion additive manufacturing.
